Hi James,here's a link to your request.
SOURCE: My Chrysler Town and Country
Did you try inserting the key in the drivers side door and locking and unlocking it manually several times to reset the alarm system. This was the problem with my 1996 Chrysler Town & Country LXI
SOURCE: 2002 Chrysler Town and Country
Ok, i'm assuming your replacing them, there is an oval rubber stopper on the backside of the rotor, in the backing plate, located near the bottom. it will tighten or loosen the e-brake shoes inside the rotor, loosen them all the way off, then get a big hammer and give them a really good smack, be carefull not to damage the wheel studs, if your reusing them hit on the hat of the rotor, if replacing you can hit right on the rotor face.
Use some antiseize on the hub before installin your new rotors, and don't forget to readjust your
e-brake and reinstall the rubber plug
SOURCE: CHRYSLER town and country mini van turn signal/flasher
I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.
Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.
If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)
Your going to replace it anyway, whats the harm?
SOURCE: Chrysler Town & Country Minivan Rear Drum Brakes
remove tire remove center pin and nut if needed and any othe bolts then pull straight off. Make sure parking brake is released or drum will not come off.
SOURCE: What does code p0032 mean in a 2004 chrysler town
Heater control circuit high, bank 1 sensor 1. Sounds like your O2 sensor in bank 1 in front of your convertor is bad.
123 views
Usually answered in minutes!
×