I need to replace door handle on driver's side of 2 door car. The handle is the type that fits vertically on the door.
SOURCE: I need to know the fuse diagram for a 1995 buick
It says that the 1 slot is for cigar lighter. Hope that helps. 96 regal
SOURCE: The driver's side and passanger's
either both outside door handles are broken or door handle linkages are loose. remove door panel for visual inspection and verify
SOURCE: i have a 94 buick
have a rod hooks to handle then hooks to door stricker one thing really need to know if power windows-locks or not
SOURCE: how to replace turn signal lever on 1992 buick
Check and make sure the back light (if the front one is out) isn't shorted. The door opening from the inside only is pretty common. You will need to take off the inside door panel. To do this you will need to remove anything that has a screw in it, hand hold, release lever etc. Once you have done this you will need a large standard screw driver or panel clip tool would be better (its 'u' shaped on the end) start from the bottom of the panel and work your way around the edges then across the top. Some panels on the top will just hook in the top of the door (prevents people from mawling the painted door) so once you have the sides and bottom un done lift up on the panel, if it still feels solid, pop the top clips off too. Once you have done this you will probably see a clear plastic, you will have to get through this. It is recomended that you replace the plastic, but not neccesary, especially something this old. You should have the window up (out of the way of linkages) and you should be able to see a linkage that came disconnected. a lot of the time it will be a clip that breaks and the linkage will just fall out. You can buy this clip from any parts store, otherwise tape will work fine, but not to tight to allow rotation. If it is the handle, you can get replacements of them too, but you will have to take the tumblers out for the key.
SOURCE: Trying to remove the door
Are you talking about the door handle hinge? The door handle and hing do not need to be removed to remove the door panel. Remove the door handle bezel and the hole will be big enogh to come straight off with the door panel. See the picture below. This is the only diagram supplied in the service manual. It shows the bezel for the driver's door but it states that the rear door is similar. If you allready have the bezel off, or you are not talking about the door handle hinge, I don't know what you are talking about when you say "hinge thing"
392 views
Usually answered in minutes!
×