I have a 2001 Ford Crown Vic. I replaced the seats with 2002 seats. The air bag light is now on. The plugs are identical. Help

Ford%20SRS%20Airbag%20Codes

leak in the bags or check valve bad or stuck.

The light is on because there is a problem with the air bag system. When the air bag light is on the system is not working and will not deploy in the event of an accident. When the air bag light is on the system has set a code in the computer a scanning device can retrieve the code. The code will give you a clue where the problem is.

you must replace the multi fuction switch! also known as the turn signal switch! its common on ford crown vic!

Take the seats belts apart and manually roll them back. Everything is the same on the 2 cars except the engine and tranny

yes there is a weight sensor under the passenger seat, did you plug it in?

Check the plugs and sockets under the seats, they tell the airbag system if there are occupants and if the readings are wrong to the airbag ecu it disables itself and lights the warning lamp, clean the plugs and sockets or sometimes I have soldered the wires to get decent contact (one at a time)

it is a code,does the horn and cruise still work?chances are the clock spring wore out and broke,its behind the steering wheel and about $100.00 part at Ford

yea its what connects the steering wheel with a ribbon for a solid contact and its is always being tested to make sure there is a connection.

you can unplug it at the compressor end and supply your own power with a couple of bits of wire straight from your battery and does not interfere with the vehicles systems.Make sure you put positive to positive etcThat will tell you it operates.You will then have to remove outlet hose to check that it is creating any pressure.The pump should have a reciever drier that keeps moisture out of the air lines Considering the age of the vehicle that part is due for replacement.Do you have a test light/probe to check if you have power to the pump?You can do this test at the compressor plug.