My NISSAN NV200 2011 front fog lights do not work.

Colin Stickland

• 22516 Answers
• Posted on Mar 15, 2009

SOURCE: Wiring front fog lights to a 2002 freelander ES.

Do not fit these lights yourself,you must take the vehicle to the dealer to have it done .Firstly as vehicle wasnt factory fitted you need the original homoglonation certificate from the manufacturer for the model with the foglights fitted,then you need a installation project drawn up by certifide auto engineer with the relevent technical qualifications (i have them) then they can only be fitted by a garage with an added value tax certificate,then vehicle must be presented to the local vehicle inspection depot to be mechanically inspected all over weither its due or not,the relevant paperwork plus the fee presented ,then a new vehicle registratrion document issued showing the changes.Failure to to this will cause the vehicle to fail its inspection when next presented as paperwork isnt correct ,the lights are ilrevelent as to weither they work or not,but if fitted from new they must work.Also if stopped by the guardis civil and paperwork checked,and they notice then you risk having the vehice impounded their and then on the spot ,big fine and the cost of the removal truck.

ZJ Limited

• 17989 Answers
• Posted on Aug 11, 2009

SOURCE: need a fuse box diagram to wire in fog lights

Fog lamps are installed on the front bumper. The switch is located to the left of the steering column on the dash panel. The fog lamps are turned off by the circuit relay when the high beam driving lamps are turned on. The circuit relay is located on the right front wheelhouse panel near the blower motor.

Good luck, and remember rated this help.
Removal & InstallationFog Lamp Element
See Figure 1

Fig. 1: Exploded view of a fog lamp assembly

1. Remove the lamp stone shields, the four bezel attaching screws, and the bezel.
2. Remove the reflector assembly from the lamp body.
3. Remove the bulb holder from the assembly. Remove the element from the bulb.

1. Installation is the reverse of removal.

1. Position the vehicle on a level surface, facing a wall approximately 25 feet away. Remove the lamp stone shields and loosen the adjustment nuts.
2. Turn the fog lamps ON and adjust as follows:
   1. Distance between the light beam centers should be equal to the distance between the lamp assemblies on the bumper.
   2. Height of the light beams on the wall should be 4 inches less than the center of the lamp assemblies when mounted on the bumper.
      
3. Install all previously removed items after turning OFF the fog lamps.

SOURCE: fog lights will not work on 2001 jeep wrangler

check your grounds on your fog lights make sure they have a good ground.GOOD LUCK.

SOURCE: Wiring for Bosch Hologen Fog Lights? Wiring

Look on the relay for the terminal numbers.
Terminal 30 goes to the battery positive.Red Wire
The two terminal 87 go to the fog lights.Black Wires
Match the color wire with what you have on the relay connection for the rest of the wires.
Terminal 86 should connect to your low beam headlight.
Terminal 85 should go to the fog light switch.
The fog light switch should connect to the terminal 85 and the other terminal on the switch will connect to ground.

SOURCE: 1998 Ford Escort dashboard warning lights and gauges not working.

Sounds like possibly the ignition switch is going out. Try jiggling the key in the ignition in the on position and see if your lights come back on.