Codes po735 and po734 dodge 1500 2003 ram

SOURCE: I have a transmission code PO732, PO734, and

Those three codes point to shift solenoid and/or clutch problems according to the Dodge Service Manual

Find someone with a Chrysler scanner and monitor the trans speed sensors, preferably the input one, make sure there is a rpm readings on both when you drive the vehicle, if ok, do a 2nd gear clutch test, if failed, internal clutch failure, if ok, replace the trans solenoid pack, it has an internal failure

Testimonial: "Thanks for taking the time to leave me some feedback about my issue. Your feedback was very helpful in helping me understand what my issue is. Thanks"

Greg Bernett

• 2993 Answers
• Posted on Jan 17, 2011

SOURCE: Code po734, po735

This is what your codes mean:

Trouble Code-P0734 (A/T Additional Gear Ratio Error In Fourth Gear)

Trouble Code Conditions:
Vehicle driven to a speed of 4-37 mph at more than 500 rpm, gear selector in 4th Gear in Drive, and the PCM detected too much difference in the engine speed and output shaft speed.

Possible Causes:

• Customer may complain of intermittent 4th gear operation
  
• O/D and 2/4 pressures less than 75 psi
  
• O/D or 2/4 clutch volume indexes out of specification
  
• O/D accumulator seals are damaged
  
• Transmission enters "limp in" mode running in 4th gear
  

Trouble Code Conditions:
Vehicle driven any forward Gear, and the TCM detected the ratio of the Input speed to the Output Speed did not match the current Gear Ratio (this test can take up to 5 minutes).

Possible Causes:

• Related Gear Ratio trouble codes may be stored (note that some of these Gear Ratio trouble codes may be intermittent)
  
• Transmission has internal problems or damage present
  

SOURCE: what kind of tranny will work to replace mine?

Will a dodge durango 4x4 tranny fit in a dodge ram 1500 4x4?