2003 Toyota, had a bit of scratch fixed by panel beaters (passenger side back door) after this the remote key is not Woking (got spare remote key, this not working as well). The Panel beaters don’t know what is wrong. Remote battery is working and the internal remote in the car is working. Took the car to the Toyota dealers, and they telling me that I will need to replace the cpu unit? They are telling me that it will cost me around $360. However yesterday the remote was working for 10 min then it stoped again? Any idea what is wrong /any advice on what I should do?
SOURCE: Procedure for removing door panel on passenger side 1994 camry
Sure.
Pull off the triangle thing.
On the door, at the front edge, there should be 2 plastic caps. Remove them. Under the caps there are screws. Remove them.
On the rear of the door panel, above the latch, are 2 round things, with a smaller round thing in the middle. Press on the inner round thing, and pull the pin assemblys out.
Do you have a light on the door panel at the bottom? If so, pry it out with a small screwdriver (it's just a "press-fit"), and remove the wire connector.
Under the arm-rest, remove the big phillips screw that is hidden, about an inch back from the outer edge of the panel. You will see the hole.
Under the arm rest, remove the tiny plastic trim cover, remove another big phillips screw.
Remove the door handle: Remove the phillips screw. Slide the handle forward or backward to release it from the door metal. Undo the clamp from the lock rod to the handle.
Remove any screws at the very bottom of the panel, if there are any.
Starting at the bottom of the panel. pull straight out, to defeat the plastic clamps tht holds the panel to the door metal. Once the panel is loose, pull it up a bit to remove it from the window opening retainer. Finally, inside the panel, unplug the wiring harness to the window switch assembly.
If you need any more info, please comment back. And, Thanks for the FIxYa.
SOURCE: drivers door power lock wont work.
Either the wring going to that motor or the motor itself is bad.
SOURCE: 1998 TOYOTA CAMRY RIGHT PASSENGER SIDE DOOR OUT
Look at these picture, step by step:
http://www.bodyshopzone.com/archives/trim/door_panels/Toyota/Camry_2000_front/removal_f4.html
SOURCE: remove passenger side mirror
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
Repairing car Door lock Actuator?
http://howtobyme.blogspot.com/2011/11/repairing-car-door-lock-actuator.html
--------
How to Access car door panel?
http://howtobyme.blogspot.com/2011/11/how-to-access-car-door-panel.html
-----
Vehicle door panel components?
http://howtobyme.blogspot.com/2011/11/vehicle-door-panel-components.html
-----------
This will help.
Thanks.
168 views
Usually answered in minutes!
Sounds like your "panelbeaters" knocked some wires loose or forgot to reconnect a ground wire inside the door. Is it just that one door or all of them?
×