About 2 weeks ago it would start missing when i would start it and the CEL would come on for a minute. Then she would clear up and the light would go out no problem and it would not do that all the time. Then until last night she is missing really bad and won't stop and CEL stays on. Please help with some information. Thank you for your time. John
SOURCE: Hello, I bought my Maxima SE
TCS and SLIP are part of the ABS system. Check the fluid level in master cylinder first. If that's OK, than you probably have a intermitent problem with one of the ABS sensors.You will need a scanner to find out which sensor in mulfunctioning, or wht the problem is. As far as the shaking condition goes, sounds like the car is misfiring. What is the code number that you are coming up with for the check engine light?? Have the spark plugs been replaced?? Replacement intarval on a 2002 Max is 105000 miles. These car seem to have a problem with the rocker cover gaskets, where iol leaks into the spark plug hole and fill the hole up, so you may need that cover, when you are replacing the plugs, but you will not know that, until you actually get inside of it. Let me know what the code is for the "check engine light" post results.
SOURCE: motor vibration
hi.bring your car to an automobile electrician.ask him to check the electronic control unit's harnesses and sockets.same thing with the engine control module's harnesses and sockets. it should be free of dirt and corrosion.
SOURCE: Nissan Maxima 1997- Battery
Sounds as if you need the electrical portion of the ignition switch. The contacts inside are most likely worn out.
SOURCE: Service Engine light flashes for short time on highway Runs Rough
You need to have the system tested for trouble codes, Kragen and Autozone parts stores do this for free.
SOURCE: 2004 Nissan Sentra 1.8S that stopped running, it
should shut off after 40 unfaulted key cycles or with battery un hooked for half hour if runs good dont be scared to drive it that wont hurt it at all
77 views
Usually answered in minutes!
×