Plymouth sundance 1992cam and head torque specs

Colin Stickland

• 22516 Answers
• Posted on Jan 31, 2009

SOURCE: i need torque specs for 1995 plymouth voyager 2.5l head gasket

start in middle and work your way outwards,torque setting??you haveing a laugh,no self respecting mechanic uses a torque wrench,pull heads down first with speed key ,making sure the bolt holes in the block are clean and no oil or water in them.then the ratchet then the nice "snap on" bar ,has to be snap on for the right amount of spring.Then use the "snap on" bar to put the final torque on and feel the bolts stretching .If your a weekend mechanic then about 80lbs should suffice but retorque them after a 50 miles or so

Earl Norager

• 355 Answers
• Posted on Oct 06, 2009

SOURCE: Need 1990 Plymouth Acclaim head bolt torque specs

WELL HOPE T Notes HIS HELP

SOURCE: Head bolt torque spec and sequence

Torque to yeild bolts need to be replaced whenever the head comes off.....Long bolts are 46 ft lbs. and the turn 90 degrees (1/4 turn) short bolts are 43 ft. lbs. and then 90

SOURCE: Head bolt Torque specs for a 1998 Plymouth Voyager

according to the manual

Step 1: Bolts 1 - 8 to 61 N·m (45 ft. lbs.)

† Step 2: Bolts 1 - 8 to 88 N·m (65 ft. lbs.)

† Step 3: Bolts 1 - 8 (again) to 88 N·m (65 ft. lbs.)

† Step 4: Bolts 1 - 8 turn an additional 1/4 Turn.

(Do not use a torque wrench for this step.)

NOTE: Bolt torque after 1/4 turn should be over 122
N·m (90 ft. lbs.). If not, replace the bolt.

SOURCE: need torque specs to replace head gasket on a 1989 plymouth voyager

Normaly supplied with the head gasket with the sequence in which to tighten them.