Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Feb 10, 2013

Hyundai tucson trunk / cargo light does not light when either tailgate or glass lifted. Bulb OK on Manual switch on light housing. Where is the switch ?

Checked bulb by switching to permenant on on switck on light housing. but does not work when set to door and tailgate or glass is lifted. Where is the switch to close circuit when back is opened.

1 Answer

L Pfaff

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Cars & Trucks Master 11,573 Answers
  • Posted on Feb 22, 2016
L Pfaff
Cars & Trucks Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jan 05, 2011
Answers
11573
Questions
0
Helped
3586757
Points
181713

Brent and Chris, just pop into dealer or call them, thay can tell you right away.

  • L Pfaff
    L Pfaff Feb 22, 2016

    Brent and Chris, just pop into dealer or call them, they can tell you right away.

×

5 Related Answers

Anonymous

  • 72 Answers
  • Posted on Apr 19, 2009

SOURCE: 2005 Honda Odyssey Tailgate Problem

Try to reset the tailgate by removing the no.7 (7.5 amp) fuse in the underdash fuse box. Open and close the tailgate manually, reinstall the fuse, and try the open tailgate button. If that doesn't work you would have take it to the dealer, where they can check for DTC's (diagnostic trouble codes). Honda Al

Ad

Anonymous

  • 1 Answer
  • Posted on Mar 31, 2009

SOURCE: 2005 Honda CRV dome light goes out, but not burned out

Filament gets fractured, possibly by vibration of the roof lining. I have replaced mine 4 times and while the bulb looks OK it is high resistance, buy a few bulbs and replace them when it occurs.

Anonymous

  • 5 Answers
  • Posted on Mar 08, 2009

SOURCE: 99 cutlass supreme headlight bulb replacement

Look at the top of the headlight assembly. There is a plastic panel on top of the assembly that is held in place by two plastic pins. Remove those pins by lifting the center of the pin and then pull out the pin. Remove the panel. Then you will find two small plastic levers that will lift about 1/2 inch. They do not come out but they will release two studs that secure the assembly. After the assembly is released, slide it forward to access the bulbs you need to replace. Installation is the reverse of these procedures.

Anonymous

  • 17 Answers
  • Posted on Jun 24, 2009

SOURCE: Reverse light not working. Bulbs have been checked

did you check the fuse in fuse box?

Anonymous

  • 776 Answers
  • Posted on Jun 28, 2009

SOURCE: trunk light and dash light always on

I would have to agree it's an electrical problem. It might simply be a defective trunk lid latch switch. Here's the wiring diagram:


278829e.jpg

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to open a tailgate from the inside of a 2019 Hyundai Tucson Must be a way?

read your owners manual page i-4 shows on left side of steering wheel on dash N0.11 is button for rear and here is a copy of owners manual for you to read https://owners.hyundaiusa.com/content/dam/hyundai/us/myhyundai/glovebox-manual/2019/Tucson/2019%20Tucson%20TL%20OM.pdf
0helpful
1answer

Hyundai tucson trunk / cargo light does not light when either tailgate or glass lifted. Bulb OK on Manual switch on light housing. Where is the switch ? Checked bulb by switching to permenant on on switck...

The best solution you'll get from books at www.reliable-store.com

These are books containing info on repair, service, troubleshooting, parts info, as sembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicle- cars, atv, trucks. forklifts, boats, excavators etc.
3helpful
2answers

How do I remove the back bumper from a 2006 hyundai tuscon?

take help of the following steps to remove rear bumper on ur tucson.

Open the trunk of your vehicle.
  1. Unscrew all the screws on the inside plastic trim that covers your bumper to trunk connection.
  2. Pry the plastic piece out with a flathead screwdriver. You will expose the bolts that attach the rear bumper to the trunk.
  3. Unscrew the bolts connecting to the inside of your rear bumper. There should be four bolts.
  4. Unscrew the two to four screws connecting to your bumper from the inside of the rear wheel tire wells. These screws are on the area of the tire well that is closet to the bumper.
  5. Slide under the rear of your car. Use a flathead screwdriver to pop the plastic rivets out of place along the underside of the rear bumper. There should be four to six rivets.

  6. Squat behind your car and firmly pull the bumper off. There will popping plastic sounds, this is the pop-in-place plastic rivets that are the last pieces that hold your rear bumper in place.
1helpful
1answer

How do you replace back bulbs at top of tailgate

The cargo lamp bulb housing is integral with he upper rear headliner trim moulding. To replace bulb housing the trim moulding must be replaced.

Also can check the repair manual: ZJ-Secc-8L-Lamps

Hope helped with this (remember rated this help) Good luck.
0helpful
1answer

Rear access door ajar

What's your question ? Tailgate ajar light lit on the instrument cluster ?
The Body Control Module (BCM) monitors the lift glass and the cargo door ajar switches. When the switch closes, the path to ground is completed, and the BCM sends a class 2 message to the instrument cluster to display the CARGO DOOR AJAR message.There are two ajar switches for the rear door ,a left an a right ,the third switch is for the lift glass ajar switch . All three of these switches splice pack SP410 At ground point G410

(Shouldn't have any readings when door(s) and/or window closed.) It's the opposite . switches are open with door closed , G410
In the Body Harness, Behind the RR quarter trim panel near the D-Pillar
It turns out it has nothing to do with rear door. Something about drivers door actuator. NO IT DOESN"T !!!!
25helpful
2answers

Want to replace brake light bulb on a 04 aviator

OPEN THE LIFT GATE TAKE OUT THE TWO SCREWS ON THE SIDE OF THE TAIL LIGHT LENSE THEN PULL ON THE TAIL LENSE TO RELEASE IT FROM THE SELF LOCKING FASTENERS YOU CAN'T SEE, REPLACE ALL THE BULBS AND REVERSE POROCEDURE.
1helpful
2answers

2004 endeavor trunk

Today is your lucky day. Get inside of your vehicle to open the lift gate and then open the glass from the inside as well . From the outside of the vehicle with the gate down and the glass open you will see the cover on the glass held in place by two screws. Remove this cover to expose the micro switch for the glass opening handle. You will see a small white connector and with a little patience you can remove this connector. If the glass switch is bad your hatch will now open and your glass should close without having to lock the locks. The switch is a dealer item and goes for around $50 and a bit more dissassembly of window to replace switch/Handle. Happened to me and cost 100 just for them to tell me what was wrong. I used a stick to poke the safty latch for almost two yrs
Not finding what you are looking for?

2,188 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...