How to go about changing oil sender switch
First need to buy oil pressure sending unit 3/8 deep socket remove oil pressure sending unit you need teflon tap sealer for oil sending unit threads.okay to replace oil pressure sending unit.you need safe raise support vechicle locate oil pressure sending unit next to the oil filter.disconnect oil pressure sending unit wire connector then use oil pressure sending unit 3/8 socket remove the sending unit.then take new oil pressure sending unit use teflon tape white plumbers tape or use thread sealer apply to the oil pressure sending unit threads then install new oil pressure sending unit and reconnect electrical connector to sending unit.then crank engine check for oil leak if all is good lower vechicle back to ground wait several minutes check engine oil level.you good to roll.
SOURCE: brake drums
There is no opening to access the rear drum adjuster. Grab a good size hammer and hit the outside of the drum directly on the flat part to loosen it up, then just pull it off. Don't be afraid to hit it hard. And remember... Don't hit the lug studs! Hope this helps.
SOURCE: how do I replace the water pump on a 1994 buick la sabre
3.8 engine you drain out coolant.remove serpentine belt and coolant hoses from water pump .then you remove pulley bolts then water pump bolts. then clean gasket surface be careful dont scratch the surfaces up.put in new pump. toque it to 29 ft the long bolts.torque .97 inch pound for short bolts.
SOURCE: need to replace fuel pump on 97 buick la sabre
it's in the fuel tank! need to get it u in the air about 4 or more feet of the ground. you may get away with it being less and there is two straps holding the tank it they are attached to the body with 15mm bolts. you will need to disconnect the filler neck where you put gas by taking the hose clamps off and then disconnect fuel lines and electrical after you have it half way down straps removed! ask any more question you have
SOURCE: 2002 Buick La Sabre. Some of the inst. cluster bulbs not light
Hello manderfield, The bulbs are replaceable but it requires complete disassembly of your cluster and above average soldering and de-soldering skills. The cluster removal process requires removing the trim molding that surrounds the cluster. There are several screws along the bottom and sides of the trim that you will need to remove before un-snapping the main section. You can lower the tilt steering wheel and place you transmission in low gear to help provide room for the trim and cluster removal. Thanks Mike www.kincerservice.com
SOURCE: How do I replace license light bulbs in my 1995
I have a 2002 which is a little different body style but it may be the same process. You have to take the back plastic section that holds the license plate loose from the car. There are bolts that are inside the trunk that hold the plastic panel on. Mine are in the trunk lid. If your plastic panel, license plate, etc. goes up with the trunk lid they are in the lid. You need deep type sockets to reach the nuts, at least mine does.
1,157 views
Usually answered in minutes!
×