I have been having problems with my blinkers for sometime, at times they would be a steady light, they finally started blinking again, then two days later they just quit. No arrow lights on the dash, and No lights. my hazard lights still work though, I still have break lights, just no blinker. I need a diagram for the blinker switch inside the steering collom
There is more than one flasher. One is for hazards and the other flasher is for directional signals. They are located under dash just left and right of the steering column. Don't go tearing up the steering column, then you are asking for trouble. Try the least expensive and labor intensive fix first.
SOURCE: 98 chevy Blazer Turn Signals quit
Combination switch in the steering column is most likely bad
SOURCE: fuse diagram on chevy s10 pickup extended cab.
flasher located at bottom of fuse box its round bout the size of a pop bottle lid,hazard flasher located at top
SOURCE: 97 Chevy truck blinkers not working but hazards do
Try replacing the Flasher first before spending to much money for a possible simple fix. If it's not your flasher then it could be the turn signal leaver.
Ok, this may seem stupid, but that's what they did to the blazer. They set the flasher near the middle and under the center console behind the radio.
It's to the left of the radio right behind the dash. The hazard flasher and the turn signal flasher are side by side. It right next to the Cig lighter behind the panel. They do mark the turn signal from the hazard flasher on the plastic behind them. Turn is on the right.
Good luck and hope this helps.
SOURCE: fuse diagram on chevy s10 pickup extended cab.
behind the radio, take the radio and the cover that goes over it. it should be there next to the hazard ligths flasher.
285 views
Usually answered in minutes!
×