Dodge Caravan 1990 front Windshield Wipers Don't Turn on.

Search Results

My windshield wipers only work on high speed...? ' Yahoo Answers

https://answers.yahoo.com/question/index?qid...
Nov 11, 2006 - My windshield wipers only work on high speed. ... If it's the compound switch on the lever on the steering wheel, it can be a bit complicated to ...

Windshield wipers - CarGurus

www.cargurus.com > Questions > Mercury > Grand Marquis

CarGurusMay 19, 2015 - Windshield wipers - My wipers stopped last week and the next day they ... slow or intermitt and only work on high speed and the washer wiper doesn;twork ... The LCM does not effect the operation of the motor or switch it just ...

Windshield Wipers only working at highest setting - Ford Flex Forum

www.fordflex.net > ... > General Ford Flex Discussions
Feb 16, 2011 - Windshield Wipers only working at highest setting ... rear wiper worksjust fine, just the front wipers only work at highest setting. ... the wipers sometimes grinds out the gears thus only working at high sppeds. If it is the motor or Transmission for the wipers, can I fix this myself and how much would it cost me.

Common GM Wiper Problem - YouTube

? 3:23
https://www.youtube.com/watch?v=kc6e2Tmar68
Oct 25, 2010 - Uploaded by roadragecustoms
The windshield wipers only worked occasionally. ... My 1998 dodge ram wipers only work on high will this help me? thanks.... Express van. you have to take out the motor and the transmission from under the front of the van..

Hey Anon,
I just finished replacing the intermittent (wiper motor pulse board) control on my vehicle.. it was doing exactly as you describe.. it wasn't hard.. just time consuming..

The wipers are controlled through the BCM (body control module) you must have that scanned to see what is going on with the system. You will need the dealer on this diagnosis.

Well first I would check the fuse box for burned out fuses. Then I would get a simple dc power tester and see if the windshield wiper motor is getting power. If you don't have a bad fuse and the motor is still getting power I would say the motor has burned out.

Dear Anne,

I don't understand the question. Struts don't pound against the bottom of the windshield. You Mean Windshield struts? I don't Get It.

Alex

check both fuse boxes,, One is under the dash inside the van, the other is under the hood,,

This is an old but very current problem also. I just replace my second 97 caravan motor in 6 months because of severe grinding noise and it was the motor both times. I got another re-mfg replacement motor last week and it is totally quiet.
Before you install the crank arm on the motor you operate the wiper switch in all positions to check that the computer is running it intermittently, slow and fast etc. that it and shuts it off at the same position every time. That shut off position is park.
Unplug the external motor connector or fuses. Now push the mechanism arms fully to the right and install the crank arm at two o'clock on the motor shaft, which gives you just enough room to install the hold down nut. Hold one of the metal bars so you don't turn the motor during tightening the nut.
Now reconnect the power plug and test the operation. The motor should shut off with the right end arms fully extended, which, when connected with the blade arm, will make them stop at the bottom of the windshield. Install the driver side wiper arm slightly above level and the left arm 4 inches below that. Don't power tighten yet. Test the operation. If they hit each other adjust one or the other away. This works for most all wiper adjustments. When you get everything looking right and sweeping the full window and not the body. Start tightening and putting every thing back together.
Also clean out the wiper pan and the two drain hoses. The hoses can be pulled loose below the pan. LOL

Mine was the Body Control Module (BCM). Switched it out (needs to be programmed) and everything was fine.

I think you need to replace the Body Control Module (BCM), My newly replaced BCM (used) fixed my wiper problem but created a new problem which the left turn signal is not working now. Time to sell the van.

it sounds like you have faulty ignition switch