Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Feb 03, 2013

2001 land rover code po733 po734 incorrect ratio

5 Related Answers

Anonymous

  • 66 Answers
  • Posted on May 05, 2009

SOURCE: sunroof leaks on 2001 land rover discovery

should be a seal issue, not mechanical. Is the roof opening/closing properly? If so, while open examine the weatherstripping and look for damage or abnormal wear. with power roofs, sometimes the movement wears down the sealing abilty pending on its usage or debris hiding inside.

Ad

Anonymous

  • 90 Answers
  • Posted on May 31, 2009

SOURCE: land rover sputtering

yes you should chek your sparking plugs, and the air filter too

Anonymous

  • 149 Answers
  • Posted on Feb 23, 2010

SOURCE: 2001 land rover discovery change air conditioner

To change the temperature reading from C to F (or vice versa), press and hold the recirculation button, then press the off button holding the switch down for 3 seconds or more until an audible beep is emitted. If the battery is disconnected and then reconnected, the temperature reading will revert to C. Turning the ignition on/off will not change the customer's set preference.
(See http://www.discotech.info/index.php?title=Climate_Control for more customer configuration options for the climate control)

Anonymous

  • 149 Answers
  • Posted on Apr 13, 2010

SOURCE: 2001 land rover discovery II locate fuel filter and fuel pump

If you're standing looking at the rear of the vehicle, it's on the chassis rail on the right hand side rear wheel arch.

Salmaneid

  • 54 Answers
  • Posted on Jul 05, 2010

SOURCE: 2001 land rover discovery II locate fuel filter and fuel pump

for Land Rover Discovery 1999-2004 no more external Fuel Filter serviceable anymore...it's a built-in part with the fuel pump. so if you want to change the filter then change the whole fuel PUMP.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 1997 audi a6 Quattro awd and I'm getting

these are sensors in the box. TR sensor/switch--shift solenoids---transmission mechanical fault.
Check all wires and connections. replace the TR sensor /switch for both gears
0helpful
1answer
0helpful
1answer

Chrysler 300M: 99 30m Chrysler have the codes po700,po734,po733,po122,po113,po108

108 Map sensor or pcm computer,113 IAT sensor or pcm,122 TP sensor or pcm, 700 Automatic trans computer or pcm, 733 Automatic trans leak or low pressure, 733 leak low pressure Your main computer(pcm) is shot start there. Then possible trans computer shot also(TCM)
4helpful
3answers

I have a 2001 vovlo s80 with the codes p1618 p0705 po733 how can i fix

PO705 is Transmission Range Sensor Circuit Malfunction. PO733 is Incorrect 3rd Gear Ration Information. P1618 means that the ECU and the TCM are not communicating properly. PO705 & PO733 can be related to P1618. Check the wiring going to the transmission. Look for a pinched wire from the car being put on a rack or possibly an accident you may have had recently. If you can find no problems with the wiring or connections then it is time to see a professional transmission expert. It may just be that the transmission has an internal problem.
1helpful
1answer

My came with a code po734 is that a big problem?

DTC P0734 - Improper Ratio for Fourth Gear.
P0734 is detected when A/T cannot be shifted to the 4th gear position even if electrical circuit is good.

This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:

Torque converter slip ratio = A x C/B

A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position (4th) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Incorrect transmission shifting

Possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit

Tech notes: Start by inspecting the transmission fluid level and condition, and change fluid if necessary.


Test and check it and send us ypur comments.
0helpful
1answer

What is code po734 and why is the check coolant light coming on and the tank is full?

2000 land rover discovery II, i have po734, po171, po174 and p1172,po1175, what can I do?
5helpful
2answers

Code po734

CODE PO734 A / T ADDITIONAL GEAR RATIO ERROR IN FOURTH GEAR, POSSIBLE CAUSES; RELATED DTCS WILL BE PRESENT, TRANSMISSION SOLENOID PRESSURE SWITCH ASSEMBLY HAS MALFUNCTIONED OR FAILED, INTERNAL TRANSMISSION MECHANICAL PROBLEMS MAY EXIST, INTERMITTENT GEAR RATIO ERRORS ARE PRESENT.
2helpful
1answer

My 2000 Saturn sl1 recently showed codes po733 and po734.What exactly does this imply and where would I start if I wanted to try fixing the problem myself?

po733- gear 3 ratio incorrect, po734- gear 4 ratio incorrect. this is how to fix. You can try replacing the shift solenoids inside the transmission as long as the trans fluid is nice and clean looking. If the trans fluid is dark or burnt looking, it time for a new tranny if you need further assistance please let me know and i will be glad to assist you. Thanks, Midwest-Tek
9helpful
1answer

Code Reads PO733 & PO734, car runs great but these two codes show up when I check it out on my scanner. Any help or advice?

po733- gear 3 ratio incorrect, po734- gear 4 ratio incorrect. this is how to fix. You can try replacing the shift solenoids inside the transmission as long as the trans fluid is nice and clean looking. If the trans fluid is dark or burnt looking, it time for a new tranny
3helpful
1answer

2002 dodge dakota code p0733 p0734

This code means gear ratio dont match from in to out on transmission in 3rd po733 4th po734 first thing to do is do a filter change and replace the fluid.LOOK for metal shavings. If you see alot could be interal problems. I have seen this fixed by a good trans flush Hope this helps
Not finding what you are looking for?

72 views

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...