I had a clutch changed on my car but they damaged the abs sensor wires.i had a new sensor put on but the light is now still on,how do i reset it please? also how do i reset my airbag light?it is a hyundai accent 1.3 year 2000
You will have to take it in to the dealer to have them reset the air bag if it has gone off if not it just might be a senser gone bad. the abs light is also the same way there will have to hook up to the car and reset the light
You have a memory code thats why lite is still on..why is your airbag lite on?it needs to be scanned to see whats wrong and to clear codes
thanks for your quick replies,do you happen to know where the port is to plug in a scanner?
my airbag light has been on since i have owned the car
under dash either side of steering column
ok i will have another look,i didnt see it there ...thanks ray
×
SOURCE: installing new brake pads on 2000 hyundai Accent GL
REMOVAL
1.
Remove the lower bolt and lift the caliper assembly up and secure it with a wire or some other retaining method.
2.
Remove the pads.
CAUTION: Do not depress the brake pedal while disassembling the pads
INSPECTION
1.
Check the pads for wear or oil contamination and replace, if necessary.
•
The pads for the right and left wheels should be replaced at the same time. Never "drop" or intermix brake pad sets.
•
All four pads must be replaced as a complete set.
•
When replacing the brake pad, check for deformation. When replacing the guide spring, use a new one or the used one after cleaning away foreign material.
2.
Check the pad for damage or deformation.
Brake pad thickness:
Standard value: 9 mm (0.354 in.)
Service limited value: 2 mm (0.0787 in.)
INSTALLATION
1.
Install the pad clips.
2.
Install the pads onto each pad clip.
3.
Insert the piston in the cylinder using the Special Tool (09581-11000).
4.
Install the new pads. The shims are attached to each pad as illustrated
Be careful so that the disc or pad isn't contaminated by grease.
5.
Install the bolt and tighten to the specified value.
Tightening torque
Guide rod bolt: 22~32 Nm(220~320 kgf·cm, 16~24 lb·ft)
SOURCE: hyundai accent, location of fuel cut off
hi from uk location of fuel safety shut off valve/switch on uk r/h drive accents is on the engine bay bulkhead in front of drivers side it is a square box with red rubber top press button may be on opposite side on l/h drives ? if activated? just press button till click ? to reset these normally only cut off on impact ? to stop elec fuel pump continuing delivering if involved in an R.T.A fire prevention
SOURCE: changing timing belt on 2004 hyundai accent
Sign up for an account on hmaservice.com. Once you do so, log in and click on "Shop". You can then enter your year/make/model and you will find the info under, engine mech. system>timing system>timing belt>repair procedures. Very detailed, and best of all, FREE.
SOURCE: In a 2000 Hyundai accent, clutch fluid = brake fluid
Yes that is correct. it should say what type right on the lid. example dot 3 or dot 4.
SOURCE: why does the airbag light stay on
Because you have a problem in that system and need check it at mechanic shop.
725 views
Usually answered in minutes!
×