Question about Pontiac Montana SV6

1 Answer

Where 2005 Pontiac Montana SV6 heater fuse in the box

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Pontiac Master
  • 1,023 Answers

On this website (link below) you find fuse box diagram and description for Pontiac Montana Sv6 (2005 - 2006)

Pontiac Montana SV6 2005 2006 fuse box diagram Auto Genius

Posted on Mar 02, 2017

Ad

6 Suggested Answers

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: real right turn signal light - Pontiac Montana SV6 2005

If the 2005 Montana is similar to the 2001 Montana, I have a solution. First you'll need a hexagonal wrench (the 6-sided L-shaped wrench). The tail light assembly is held on by two screws. You'll need the hexagonal wrench to remove them, because a normal screwdriver won't do it. I also had to use a conventional adjustable wrench to get the leverage to turn the hexagonal wrench, because the screws were in there pretty tight. Once you remove the two screws, the whole tail light assembly should come off. Mine required a little force and I had to play with it a bit, but it came off without a lot of work. There will be one set of wires that connects the tail light assembly to the rest of the minivan--try not to damage that set of wires. Once you get the tail light assembly off, you'll have to take apart the assembly that actually holds the lights. No tools should be required. It's held on by four plastic catches. Just undo the catches (easier said than done, but still not too tough) and it comes apart. Then you can pop out the old light and pop in the new light. Then re-assemble. For me, it went back together much easier than it came apart.

Posted on Jan 03, 2009

Warperbs

  • 7 Answers

SOURCE: 2005 Pontiac SV6 Montana key fob unlocks doors but will not lock

For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.

Posted on Feb 14, 2009

Anonymous

  • 2 Answers

SOURCE: where is the bcm program fuse on a 2005 pontiac montana sv6

The BCM program fuse on a 2005 Montanna SV6 is called something different in the manual. It's called a “Keyless Entry Module” fuse and it is fuse #7. The fuse panel is located on the passenger side on the side of the dash. There is a cover with an indent hole in it to pull the fuse cover off. It's really hard to pull it off and it almost seems like your going to break it when your trying to get if off. Keep pulling, it will come off! On the fuse cover, fuse #7 is labeled " RFA MDLS" which is again different than what is in the manual. I followed the procedure to reprogram my "Key Fob" and within 45secs, I had reprogrammed my key FOB! I was so excited, because, I have been trying locate the BCM fuse for 4 weeks. I think GMC does not want us to know it’s location or name, so you would have to go into a dealership to get your Key Fobs reprogrammed costing about a $100 for a minute of work.
e65ae06.jpg


1. Keep the windows open as a safety measure, then,
2. Remove the ignition key from the ignition lock cylinder.
3. Remove the “RFA MDLS” (fuse #7 ,BCM PRGRM fuse, Keyless Entry fuse) from the fuse panel.
4. Close all of the doors.
5. Close the liftgate.
6. Turn the ignition lock cylinder to ACC.
7. Turn the ignition lock cylinder to OFF, and then back to ACC within 1 second.
8. Open and close any vehicle door. A chime will be heard when the system enters the BCM programming/diagnostic mode.
9. Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds.
10. Important
After 7 seconds, a chime may be heard confirming successful programming.
11. Repeat the previous step on each additional transmitter to be programmed.
12. Remove the ignition key from the ignition lock cylinder
13. Install the “RFA MDLS” fuse ( fuse #7 ,BCM PRGRM fuse, Keyless Entry fuse) back into the fuse panel.
14. Press on the key fob functions (EG. Lock, Unlock) to verify correct operation.

Posted on Jun 08, 2009

Anonymous

  • 1 Answer

SOURCE: Where is the cabin air filter on my 05 montana?

In the Glove compartment on the left hand side there is a black snap on cover pull it from the bottom and it will come open. There is 2 filters in this spot.

Posted on Jun 28, 2009

Anonymous

  • 32 Answers

SOURCE: Where is the fuse box for a 2006 Pontiac Montana

on the driver side under the dash or the side by the door jam

Posted on Apr 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removing a defective blend door on the pontiac montana sv6 2005


removing the heater a c box from under the dashboard

Sep 20, 2014 | Cars & Trucks

1 Answer

2005 PONTIAC MONTANA FUSE BOX DIAGRAM


On this website you find fuse box diagram for Pontiac Montana SV6 2005 - 2006

Pontiac Montana SV6 2005 2006 fuse box diagram Auto Genius

Mar 02, 2013 | 2006 Pontiac Montana SV6

1 Answer

Service ABS and traction control systems is displayed in my 2005 pontiac montana sv6. New breaks have been installed and lights and system still on. Scanned and shows no sign of sensor issues


well this is a sensor problem. just cause you didnt get a fault code dome mean that the sensors are ok. Remove the abs Fuse from the fuse box under the hood. Drive the car and get a feel for the braking. Replace the fuse and drive again, you will notice one or more of the wheels dont hold as it fast or faster than the rest. Replace that sensor.

May 07, 2011 | 2005 Pontiac Montana SV6

1 Answer

I can't find the fuse box on 2005 pontiac montana because drivers side blinker clicks really fast but doesn't work.


sumtimes they put the fuse panel behind the glove box, if its not under the hood or under the dash

Jan 15, 2010 | 2005 Pontiac Montana SV6

2 Answers

I have a 2005 pontiac Montana. The heat in the


There is a flap in the venting itself that can get stuck. Or the actuator that moves it can become faulty. It is located above heater core and it's housing. You will have to remove bottom console to access it.

Nov 17, 2009 | 2005 Pontiac Montana SV6

2 Answers

Is there a fuse for the rear wiper on a 2005 pontiac montana


There are 2 relays and one fuse. the locations are all detailed in your owners manual (one relay under the hood, a fuse and a relay in the cabin on the passenger side fuse box)

Apr 14, 2009 | 2005 Pontiac Montana SV6

1 Answer

2005 Pontiac SV6 Montana key fob unlocks doors but will not lock


For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.

Feb 12, 2009 | 2006 Pontiac Montana SV6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

242 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...