Depending on the bumpiness of the road, I can occasionally see a loose screw rolling around behind the driver's side view mirror. The hood portion of the mirror assembly seems slightly loose, vibrating when I get up to highway speed. My goal, if possible, would be to remove the mirror portion only, so that I can return the loose screw to its intended location.
SOURCE: Miata has 61000 miles want replace timing belt to be on safe side
California has a law that Mazda guarantees the timing belt will last 105,000. I drove my 1999 Miata that long before I replaced it. Mazda ia a non interactive motor which means that if the belt breaks the car stalls and won't go anywhere. No damage to engine if it breaks.
SOURCE: How do you adjust the headlights on a 2002 Mazda Miata?
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
SOURCE: how to remove a 1999 mazda miata oil pan
you will need to most likely pull the engine to give you the clearance needed to remove the pan all the way
SOURCE: to remove a 2002 mazda tribute tail light
Once all of the hardwae has been removed then you need to pull the assembly toward the center of the vehicle while pulling outward on the inboard edge of the lens.
SOURCE: My 2005 Mazda 3 driver's side windshield wiper is
there is a plastic cap at the base, pull the cap off you will see a nut. take the nut off, lift the arm, a little rocking but no prying please. take a close look at the serrations inside the base of the arm. if they are stripped smooth then you need a replacement arm. these can be had at the dealer or used at a junkyard, if you go used please examine it to make sure it is not also stripped and that it is the right arm, left and right arms are usually not the same. put back on in reverse order, use some loctite on the nut.
351 views
Usually answered in minutes!
×