Just had a new steering column put on my 96 towncar. now evert time I open my door it beeps loud and wont stop till car is started. what is wrong

You may have an ignition switch that is out of adjustment or is starting to come apart. It is located in the steering column

maybe the engine of your car is wrong ,you can check it ,or check if the car key programmer have something wrong .

Power steering fluid is low. If that is ok then you have a bad water pump or power steering pump.

Maybe one of the door switches, are worn or broken, worn ones can sometimes be adjusted to make the stick out. Push the door switches in one at a time with just that door open, (it should be on the door jam), if it stops, you've found the problem switch. Since the driver's door get much more use than any of the others, I'd start there.

check to see if the wire is broken for the passlock/passkey system in the ignition lock cylinder, its common for the copper wire to seperate inside the insulation, when you tilt the column it could have been pushing the wires together enough to touch inside the insulation

Dealer, but did you check the Power steering fluid level??or any leaks. There are two hose that connect to the gear box from the power steering pump. if the pump is low on fluid you lose your power steering, if the hose has a leak or it blew and lost the power steering fluid then you lost your power steering again. 
Check the fluid level to the power steering pump and any leaks or broken hose to the gear box.
Keep me posted, be glad to help and good luck.

(1)look at the wires in the steering column where it adjust up and down and see if some wires are touching inside the steering cover.
(2) it a reason to suspect a bad ground to the motor also will cause it too

your mechanic is wrong!!!!cause i have never held of or come across a module doing such things.

Double ck the wiring connector.

All you need to do is turn your steering wheel to the left all the way till it stops then put your key in while still holding the steering wheel to the left, turn the key to the on position this should release your steering wheel!

clockspring is behind steering wheel.

info

96 escort

If the computer in the air bag diagnostic monitor detects an open in the air bag indicator circuit and if another system fault exists, then the air bag diagnostic monitor will turn on its internal tone generator (beeper). The beep pattern is five sets of five beeps. The pattern is repeated every 30 minutes while the ignition switch is in the ON position. The five beeps do not indicate a code five or any other code. The air bag indicator circuitry must be repaired before the diagnostic trouble code can be read.