Question about 1995 Honda Odyssey
If it's leaking from the oil filter spacer.( the 2 inch metal ring that attaches to your block, and has two rubber hoses coming out of it, and your oil filter attaches to) There is an o-ring between the spacer and the block. Take off your oil filter, remove the oil filter stud with 1 3/16" socket( or metric equivalent) and the spacer will come off. I found all the auto parts stores around me said that the o-ring was a dealer item. I bought a FRAM PH3387A oil filter and removed the o-ring on that. It fit perfectly, snug down your oil filter stud to specs, then install your oil filter. Double check that the oil filter is not double gasketed, and your are fixed!
Posted on Feb 11, 2009
Check for a double oil filter gasket or a missing oil filter gasket. If it's still leaking after new filter with proper gasket seat on oil filter look higher on the engine.
Posted on Feb 02, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
If it is not the suggested gasket that is leaking then it is the oil pressure switch located exactly above the oil filter adapter. The black plastic housing could have developed a crack and oil will ooze downward and drip off the bottom of the adapter. I had this problem and changing the oil pressure switch took care of it.
Posted on Dec 18, 2008
I own a '99 Isuzu Oasis, which of course is really and '98 Odyssey with Isuzu nameplate. 214,000 miles, Cranked it up yesterday morning after 20 to 30 degree temps that night....took middle schooler to class approx 3-4 miles from home and approx 1/4 mile from home- noted severe burning oil smell in cabin and smoke from under hood.. Got it home and observed 3-4 quarts of leaked oil on the ground where I had been sitting just 15 mins before. Thought for sure I had ruined the engine after seeing all the oil in the gravel. Could not believe the leak was so severe, considering this car still runs like a beauty and has shown no leaking or other symptoms in the days before this occurred. Got home later that day and checked filter thinking maybe it had loosened. It had not. Refilled engine with oil and noted oil not leaking or dripping but pouring through area at engine block and oil cooler juncture at filter area. Found this forum and a few others on line and followed the plan , AutoZone: loan-a-tool 30mm 1/2" drive socket is all you need to do the job, except of course the oil cooler seal/O-ring which I got at Honda for 3 bucks. Took me all of 45 mins...no need to dettach hoses and leak antifreeze, just unscrew the 30mm nut and remove the old gasket/seal. Be sure to remove all the pieces, Mine was hard and brittle and broken in 3 pieces. What once was rubbery/pliable would now snap like a pretzel due to age/wear. When I buy my next one of these, and I will, because it is the best vehicle I have ever owned ( and I have owned several Hondas and Toyotas) I will preventative replace this seal at approx 150,000 miles.... this was close to being catastrophic failure- Thanks to this forum and others for the advice-plan to put another 100,000 miles on this baby!
Posted on Jan 07, 2010
oil filter screws onto an adapter housing which also has the pressure sending unit on it (above oil filter). This adapter housing bolts to the block with 3 bolts. if oil appears to be leaking from where the adapter housing meets the block (especially at the rear side of engine near bottom), then you need to replace the siamese o-rings between the adapter housing and the block ($12 part at dealer). remove lowest 12mm bolt and loosen top 2 12 mm bolts(top 2 bolts won't come out unless you drop the engine down, but loosening 1 inch is all you need), replace o-rings and retighten bolts. be careful not to get dirt/grit between block and adapter. just finished doing this to son's 95 2.7 v6 which was leaving an 8" puddle of oil after idling for only 1 minute-worked perfect
Posted on Feb 25, 2010
Tips for a great answer:
Sep 21, 2014 | Cars & Trucks
Feb 20, 2012 | 1991 Lincoln Town Car
Apr 03, 2011 | 2005 Nissan Maxima
Jan 26, 2011 | Mitsubishi Eclipse Cars & Trucks
Jun 06, 2010 | 1997 Ford Taurus
Feb 02, 2010 | 1998 Oldsmobile Aurora
Mar 23, 2009 | 2000 Volkswagen Beetle
Nov 27, 2008 | 1984 Ford F 250
Dec 30, 2016 | 1995 Honda Odyssey
1,002 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: