SOURCE: 1999 nissan quest brake pad replacement
Remove wheel & tire,
remove 2 torx bolts that go from the inside to the outside of the vehicle. They are on the inner side of the brake caliper.
lift the caliper out of the rotor.
remove the brake pads.
To install, you must first squeeze the caliper piston back inot its bore. Do this slowly to prevent damage to the piston. You are forcing excess brake fluid back into the master cylinder reservoir. Slow constant pressure will get the job done. Use a large c clamp or a wooden hammer handel if that's all you have.
Fit the new brake pads in the calipers and slide the assembly back over the rotor.
install the 2 torx bolts, size 40? head I think.
You are done.
If rotors are scored bad, replace them too.
SOURCE: replace control panel on 2004 nissan quest
there is a c-clip you need a small screwdriver to pull it out then gearshift knob will pull off
SOURCE: 2001 nissan quest alternator voltage
First you need to narrow it down to what is making the noise. It could be the power steering pump - water pump - air conditioning compressor or the alternator (some older vehicles had smog pumps)
Then you'll have to go from there...
SOURCE: NEED TO REPLACE ALTERNATOR MYSELF
here's 96. should be the same. Be very careful not to overtighten any of the belts or you can break the snout off the crankshaft and ruin you engine.
Section 14-02: Generator, Integral Regulator — Internal Fan and Regulator Type
1996 Villager Workshop Manual
REMOVAL AND INSTALLATION
Generator
Removal
Installation
To install, reverse the removal procedure.
Tighten the inner generator-to-bracket bolt to 23-26 Nm (17-19 lb-ft).
Tighten the outer generator-to-bracket bolt to 23-26 Nm (17-19 lb-ft).
Tighten the generator locking bolt to 16-20 Nm (12-15 lb-ft).
Adjust the drive belt very carefully. Refer to Section 03-05 for the procedure.
SOURCE: I need to replace my Nissan Quest 2007 in cabin micro filter
I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.
Testimonial: "Finaly I found the air flow door with three screws and removed it. The filter will need replacement soon. It is been replaced one time at the dealer."
372 views
Usually answered in minutes!
Check this video outhttps://www.youtube.com/watch?v=YAfu3Rmd...
×