What can I do to get it out of first
SOURCE: chevy s10 4 wheel drive will not engage
There is a vaccuum operated switch located on the transfer case that sends vaccum to the accuator that pulls a cable that locks the front end in. Check for vac coming in and out of this switch if no vac out replace it. This switch is a very common problem. You can find them at most parts stores in the help section #49315. please rate.
SOURCE: 1994 chevy s10 blazer 4x4 push button type
small sylinoid on the top of the transfer case needs replaced. easy to do. it has three vacumelines going to it just trun out and replace like a bolt.
SOURCE: 1994 chevy 1500 $ wheel drive wont engage
your problem is probably the front axle solenoid. it is in the center of the truck on the front axle and it is really easy to change. Simply unplug the electrical connector and use a wrench to loosen it. Spin it counter clockwise until it comes out........Manual hubs i believe are not available for this truck but i think there is a aftermarket cable you can buy and install to lock the front diff in.
SOURCE: My 98 s10 is stuck in 4 wheel drive low.
Pull the kick panel on the passenger side. there is a small box mounted there that is the computer that controls the actuator for the 4wd system. this is notorious for problems due in fact that the connector likes to pull out and away from the module. I had the same problem and the solution is simple.. take a long zip tie and get it between a few of the wires and around the module. tie it in and have a nice day.. it wont come off or try to pop out anymore and you should have no issues getting into 2wd, 4wd h, 4wd L.
SOURCE: stuck in 4 wheel drive and wont come out.
hey there i cant tell you what you are missing but i can tell you how to disengage the front wheels . ok you have a vacum line that runs right under the battery and a line that comes up from the front diff. to the same place ( you may have to remove batt and batt tray to get full access to this) un bolt it and temporaly put batt and batt tray back in start it up and decompress this and see if it comes out .... you should here clunking noise if it goes back in ... if thats the case just pull that big vaccum line off .... to test get all four tires off the ground and have some one put it in drive but dont hit the gas it should turn on its own ...if that dont work check the cable that runs down to the differental
285 views
Usually answered in minutes!
it does not come out 1st gear at all or when i push in the pedle and the truck has new clutch and slave cylinder what can i do l
×