2000 model Landcruiser GXL I've bought a new remote door lock and I can't code it in. Instructions say to open door/lock then unlock doors/turn ignition from acc to on 20 times, then leave on 'off' (assume 'lock'). Indicators are meant to flash 20 times and then I press buttons on all remotes. But i never get the indicators to flash. When I try again, indicators flash 16 times, so assume I'm into some other programming mode. Can you assist? Thanking you very much in advance.
SOURCE: Remote door entry not working
could be that the remote lost memory during battery change may need to reprogram
SOURCE: remoe dont lock or unlock the doors. hazard lights, indicators and horn dont work.
You might have a blowen fuze. I would check that first. If it is blowen and continues to blow after replaceing it, then you have a short somwere in the wiring.
SOURCE: 91 landcruiser 80 series gxl replacement drivers seat
You can get a replacement seat from a wrecking yard and would guess you would pay around $75.00 to $100.00 for the seat or you could go to a reupholster and have it redone like new for somewhere around $150 to $200.
SOURCE: net.com.auWheel nut torque setting for
Here is the full sequence for setting the bearing pre-load and torquing the wheel nut:-
Torque inner nut to 43 ft/lbs
Turn rotor 5 times, left & right
Torque inner nut to 43 ft/lbs
Loosen inner nut until it can be turned by hand
Torque inner nut 3 ft/lbs (48 in/lbs!)
Check that bearing has no play
Measure preload w/tension spring (6-12 lb)
Install lock washer & lock nut
Torque outer lock nut (47 ft/lb)
Check that the axle hub turns smoothly and that the bearing has no play.
Measure preload w/tension spring (6-12 lb)
(Repeat, starting w/inner nut if not within range)
Secure the lock nut by bending one of the lock washer teeth inward and the other lock washer teeth outward
http://65.164.43.42/SMPTools/upload/BWD/Documents/Catalog/BWD_WC_Illustrated_Guide_06.pdf
check this file may be it helps you
71 views
Usually answered in minutes!
×