1989 Honda Prelude Logo

Related Topics:

Posted on Jan 28, 2009

97 acura integra idle rough when cold and

I replaced the idle air control valve

1 Answer

ya_shurik

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 35 Answers
  • Posted on Aug 14, 2009
ya_shurik
Contributor
Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Aug 14, 2009
Answers
35
Questions
0
Helped
12193
Points
85

Where are the rpm's at when its idling cold?

if the cold idle is below 1500 rpm. adjust it by tightning/loosing the intake spring located on the intake manifold.

if it does it reguardless of rmp. replace the spark plugs.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

96 acura idle rough an when I'm sitting still an turn the steering wheel the car dies please help.u can email @ [email protected] thank u

a vacuum leak. cold fuel system is enriched. any extra load could cause it to die. what TL? 2.5? idle air control valve? TPS ? check for codes!!
0helpful
1answer

1992 acura integra wont stay running

Try the procedure below.

Here are the most common causes of idle surge, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake

0helpful
1answer

Car idols rough no power

0helpful
1answer
0helpful
1answer

High idle on cold start on a 86 dodge d50 2.0 liter

0helpful
1answer

98 dodge ram 1500 5.2 the truck will start but it will not idle.

0helpful
2answers

My 91 acura integra is stalling after idling for just a few minutes. I just bought the car and it ran fine until just recently. I also noticed a gas smell after the car started again.

Idle is controlled by two main sensors: the FITV and the IACV. The FITV is a mechanical valve that is controlled by coolant temperature (there is no ECU plug to it). When the coolant is cold, the valve is open and letting air into the Intake Manifold through a hole in the Throttle Body above the throttle plate. This creates a small vacuum leak which in turn lets the motor idle higher than normal (supposed to be above 1K RPM for warming up). As the coolant warms up the valve closes and no longer lets air in through the hole in the throttle body. From this point the IACV, which is Engine Control Unit controlled, is letting small amounts of air into the Intake Manifold through another hole in the Throttle Body. Any amount of extra air the ECU is not expecting will confuse it and you will get either a high idle or a roaming/hunting/fluctuating idle. The principal of engine to operate is a need to have a Fuel : Air ratio of 14.6:1. You smell the gas after restart since the unburnt gas, when the engine dies, got pushed out through the exhaust manifold.
Th following are in order one after the other until it fix problem.
1- Find and replace the vacuum leak on hoses mentioned above.
2- Clean the the gunk built up at holes mentioned above.
3- Replace thermal valve at engine block identified by two vacuum hoses connecting to the Throttle Body.
Good luck.
6helpful
3answers

'95 Acura Integra~ Loss of power, lesser gas mileage, rough idle

my 96 integra is idling rough and bogs when i step on the gas i have replaced spark plugs,disb cap, rotor,wires,both o2 sensors,pcv valve and timing belt water pump replaced not long ago looked for vacuum leak can't find any. what could be the problem am i missing something
Not finding what you are looking for?

701 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...