HOW DO YOU EXTRACT THE HEADLIGHT HOUSING, IN ORDER TO CHANGE THE BULB? I REMOVED THE TWO LONG SCREWS. BUT CANNOT PULL THE HOUSING FORWARD. DO YOU HAVE TO REMOVE THE WHOLE FRONT BUMPER?
Thought i already answered this... must have been for someone else... you should be able to access the bulb from within the engine compartment... if it's on the side of the battery you may have to remove it. do not touch the bulb with your fingers as that shortens the life of it.
Robert
REMOVAL
Release hood latch and open hood.
Remove large rubber grommet (70 mm x 168 mm) from splash shield to gain access to fascia fasteners Access Rubber Grommet
Remove fasteners attaching fascia to the front fender and splash shield, using access hole in splash shield Fastener Locations
Remove the push pins attaching the fascia to the upper radiator closure panel Remove Push In Fasteners
Remove jackscrews attaching headlamp housing to crossmember and remove the lamp housing to access the lamp(s) Headlamp Jackscrews
Roll fascia forward to clear way for headlamp housing removal Roll Fascia Forward
Disconnect wire connector from back of lamp socket(s) and/or bulbs.
Remove headlamp housing Remove Headlamp Housing
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs with fingers or other possibly oily surface, reduced bulb life will result.
Place headlamp housing into position.
Connect wire connector to lamp socket(s) and/or bulbs.
Verify headlamp and signal lamp operation.
Install jackscrews to attach headlamp housing to crossmember.
Align fascia to bumper reinforcement and install the top center push pins, to upper radiator closure panel.
Align the two fascia studs to the fender vertical attachments, at the same time align the fascia groove on the horizontal flange with the fender drive pin. Push fascia rearward to engage the fasteners.
Install nut on fascia stud through the splash shield access hole.
Verify headlamp operation and alignment
that should help.... perhaps if that does assist you better .. please change the rating on this solution... thanks
×
3,411 views
Usually answered in minutes!
this is impossible as there is no space large enough behind the housing to extract the bulb. this is the driver side headlight on a chrysler concorde 2000. this is the first time that i have requested info from your site.
I accidently ripped the right front bumper forward from a wood box. I didn't see it underneath all the snow. How do I fix it?
×