SOURCE: Turn Signal Flasher location in 93 Mustang GT
The flasher is a small round plastic cylinder (unless replaced with a metal one) behind the left edge of the glove box that will look similar to the one in the fuse panel. The first step is to squeeze gently both sides of the open glove box and let it swing downward. It will be snapped into a metal horizontal brace just to the left of the glovebox opening by a small tab and have two wires attached. The number more than likely will be a #552 although I have seen a factory one with a Warner #224
SOURCE: No turn signals or emergency blinkers
Sounds like a multifunction switch, work the emergency flasher button up and down a few times, then attempt to work the turn signals if the signals work then you will need a multifunction switch.
SOURCE: where is the turn signal\hazard flasher located?
it's in the auxiliary relay box behind the glove box.
13350 is base part number on flasher
Testimonial: "Actually found it located behind the radio mounted on a brace. Removed cover and relay pulls out. About 1" cube with 5 terminals on it."
SOURCE: Where is the turn signal relay, hazard relay, and
It is not the flasher if the hazards work, it is 1 flasher for both turn signals and the hazard lamps. It is in a relay block ( along with the blower motor relay ) under the dash, about in line with the steering wheel column ).
Try tilting the steering wheel all the way up, and test again.
The other quick test is to cycle the hazard switch a few times, to see if it cleans the contacts for the turn signal on the MFS,
SOURCE: My blinkers are not working.I
are you sure you replaced the signal flasher and not the hazard flasher as they look the same.put the hazards on and check to see if it was the one you replaced.if it is then you need to located the signal flasher and replace it.if you still have the old one you replaced you can use it.
205 views
Usually answered in minutes!
×