Question about 2002 Toyota Avalon

1 Answer

When driving 40mph let go of steering wheel car pulls to the left ,2002 toyota avalon

When driving 40mph let go of steringwheel car pulls to the left

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Try flipping the front tires right to left and so on car may have a radial pull road test to see if it goes right or strait (first check tire pressure )

Posted on Jan 17, 2013

Ad

4 Suggested Answers

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Daniel

  • 19 Answers

SOURCE: Steering wheel locks up at times while driving. Can I take the pin out?

try switching out the coulmn lock and check steering box and linkage

Posted on Sep 03, 2009

Anonymous

  • 73 Answers

SOURCE: my 2006 Toyota Highlander is making a DRONING

You probally have a bad front wheel bearing , when the noise changes when you move the wheel is typical of a bad bearing.this should be covered under your powertrain warr.

Posted on Sep 21, 2009

Larry Gutman

  • 239 Answers

SOURCE: 2003 Toyota Corolla Wheel Alignment

The specs are what the manufacturer recommends for the vehicle when it leaves the factory. However that means with the original tires and condition. The caster is not adjustable on a Corolla, so if the vehicle pulls even with the tires switched, there is a possibility there is damage to the strut or steering parts. However, before changing anything, check all tire pressures and make sure the brakes are in good condition. A brake that is not releasing properly will cause a pull to that side. Individual toe is rather meaningless - the total toe is what is measured. You have no king pins on a Toyota so you will not have KPI.

Posted on Jan 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

94 grand marquis shakes at 40mph til i let off gas


Check the fuel pump and plugs{coil}

Dec 15, 2013 | Cars & Trucks

1 Answer

Why won't my 1990 crown victoria, drive over 40mph. To go over 40mph I have to be in drive 2


change out both the speed sensors for the transmission...when one goes bad the next will soon follow. A call to a parts store or ford center can get you the location of where they are located.

Jan 17, 2013 | 1990 Ford LTD Crown Victoria

1 Answer

Car pulls to the left when you let go off the steeringwheel


Low tire pressure on that side or you need to get it aligned

Jan 16, 2013 | Toyota Avalon Cars & Trucks

1 Answer

Where's the turn signal switch located?


ist called a flasher relay and its located under the steringwheel by you r fuse box it might be blue but it should say flasher

Aug 06, 2012 | 1995 Chevrolet Caprice Classic

1 Answer

Vibration from 25mph to 40mph


Get your tires rotated balanced and check drive shaft for issues would be my best bet, does it pull to one side as well? also stupid question i know but how old are the tires and have you checked for damage?

Jun 09, 2012 | 2002 Buick Century

1 Answer

Recently noticed when driving over 40mph, I hear a loud humming like tire tread noise, coming from the front. When I'm turning right it gets worse. Turn left and it virtually vanishes. Is this the...


yes.this means the left wheel bearing is bad, because when you turn right the pressure is pushing down on the left wheel causing noise and when you turn left the pressure then pushes down on the right side removing pressure from the left side causing noise to stop.. this is why when you turn one way or the other the noise stops and starts.

Jan 16, 2010 | Chevrolet TrailBlazer Cars & Trucks

1 Answer

Speedometer quit working. Resting at bottom


yes you can! most front wheel drive sensors are on the front of the transmission.

Jun 18, 2009 | 2005 Chevrolet Cavalier

1 Answer

Main belt vibretes at 40mph and it rips off.


Obviously have to take a close look at pulley conditions & alignment, as well as tensioner. While the belt is off, check each pulley by trying to spin it for excessive resistance, and or movement, side to side, up & down, feel for grinding like indication bad/dry bearing. Try applying a little force in direction that belt would when it's on, as you rotate pulley, as it may only show or feel it when force applied. Remember, when you accelerate, crankshaft pulls harder on that belt & if tensioner isn't keeping proper tension on at all times due to partially seized or weak, it will allow belt to loosen up & bounce on opposite side from pulling.

Apr 04, 2009 | 1998 Chrysler Town & Country

1 Answer

Why does my 1994 cadillac sedan deville go in reverse but not int


lost my overdrive,car runs fine,wont shift after it gets up to 35-40mph in drive,to drive it i have to use l1,l2,etc.where are relys located or solinoids?

Mar 22, 2009 | 1994 Cadillac DeVille

Not finding what you are looking for?
2002 Toyota Avalon Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...