Pcm location on a 2008 f350 - 2008 Ford F-350 Super Duty

https://www.powerstroke.org/forum/attachments/6-4l-problems-forum/599017d1486301058-2008-f350-fuel-temp-sensor-location-p0183-code-303-14b.-engine-electronic-engine-controls-diesel-engine-removal-installation-fuel-temper.pdf

Dealer .

This is on a 2006 don't now if yours the same
You need to remove the driver side battery and then the pcm is located on the inside of the fender just behind were the battery was and I believe that there are 2 10m bolts holding the pcm in there and unbolt it and look at the bottom of it, should have 3 letters and a number.

Where is the fuse box located in the 2008 ford f350 truck Google Search

click on link and scroll down for picture of location

The PCM power relay is the furthest most relay opposite of the PCM diode, it is the front or rear of the battery junction box.

According to the book, the ignition module for the 10 cyl engine is part of the PCM computer.

The 2006 Ford F350 Powertrain Control Module is located in the Top, Middle of the Firewall when looking under the Hood, behind the Engine.

Here is the Service Procedure with Diagram of the PCM:
http://www.4shared.com/document/jJK8SGad/2006_Ford_F350_Powertrain_Cont.html


I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

po603 is pcm keep alive memory error. either have pcm tested or replace pcm. because the pcm is at fault.

that fuse powers pcm fuel heater and some other things. when the fuse blows the pcm shuts down. causing it to not run. usually its the heater that is bad. it is located at the back driver side by the fuel pump. you can unplug it and see if it starts. if so you will need to replace the heater

Slot 24