Cars & Trucks Logo
Anonymous Posted on Jan 13, 2013

05 nissan titan engine starts but will not stay running and slip light stays on

My slip light came on today and when i tried to start my truck it wouldnt stay running, i had some help with my friend he added some break fliud and said it could be the problem for the slip light.. it was not.. i checked my semi-new break pads and the're still have a long way before bad, also they are in proper placement. my fuel pump went out two weeks ago so i also checked the wires that plug into the fuel pump.. i just bought this truck with 30,000 miles and i know there good trucks but this is getting rediculous. does anyone have any tricks, tips or pointers to help me find the solution?

  • Anonymous Jan 13, 2013

    i just did the test and i got this code- 0106

×

1 Answer

ken hane

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Nissan Master 450 Answers
  • Posted on Jan 13, 2013
ken hane
Nissan Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Sep 28, 2012
Answers
450
Questions
5
Helped
145434
Points
1415

I'll try, ???., clear any possible trouble codes from computer, check all fuses, if computer has any codes stored, retrieve them first. this may direct you in the right direction as to what your problem is. a parts store can do that for you if you can get it there. if not, try removing the negative battery terminal, for a few minutes, give 5 min., reinstall, then try to start. any luck ? you say your 'slip' light stays on , what sensor sends this info, wheel sensor ??? front or rear ?? why would this prevent your engine from running ? this would be rediculous ! maybe its something else, fuel pump ? sure your connection to new fuel pump is good? try this, with out starting engine, (have a helper) turn on key, donot start, have a helper do that, you go back to tank, (intank pump) listen for a hum, which only last for 2-3 seconds, upon your helper turning key to on position. listen closely, do this a couple times, do you hear a humming ? if yes, pump is working, if not, well there ya go. next, check fuel pump relay, fuse, most found in the engine compartmt. see if any of this helps, good luck, patience is a virtue !!!

3 Related Answers

Anonymous

  • 306 Answers
  • Posted on Mar 10, 2010

SOURCE: 1995 nissan pickup truck fuel problem

Fuel injected or carb? Make sure fuel line itself is clear. Some pumps are designed to self regulate (carb systems) some continually pump and a psi regulator sends back the excess fuel back to the tank (fuel inj systems) If the line is obstructed then pump can't deliver fuel fulltime.

If you think pump is not on consistent, try running a dedicated wire through a switch directly to the pump. If it works then you are looking for an electrical fault going to pump. Good luck.

Ad
pal03246

Phil Lovisek

  • 726 Answers
  • Posted on Jul 24, 2008

SOURCE: 2004 Nissan Titan

do a gauge test. turn off the key and hold the trip meter reset knob. while you are holding the knob, turn the key to ACC position and hold knob for 10 seconds. this will put the cluster into self diag mode. after that happens, let go of the knob and just push it slowly / repeadly and observe the cluster assy. It should be changing and all kinds of stuff should be happening. Don't be scared, you can get out of the self diag mode simply by turning the key off again. Test gauges since those are part of the CAN cyctem also. If NG that you may need a new cluster assy.

Anonymous

  • 9 Answers
  • Posted on Nov 07, 2009

SOURCE: nissan titan truck wont start. positive

is the battery swollen on the sides or front(bulge) bulging batteries = dead cell
= new battery

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My 2006 Nissan Titan Slip light comes on at start up. At this time, the 4wd display tree in dash is not showing up. After truck warms up at idle for several minutes, or is driven for a couple miles, the...

Most likely a wheel speed sensor starting to go bad, possably a wiring or Modual Issue.

You would have to pull the code with the light lit to tell you were to start the Diagnosis.
0helpful
1answer

2005 nissan titan slip light stays on

You checked to see what codes you may have?

Always start there,no matter what the issue with
any vehicle
4helpful
1answer
3helpful
1answer

My brake, slip and VDC indicators stay on.

Check brake fluid level, add fluid from sealed container if needed.

Also check for leaking rear axle seals. Look for oil on the inside of rear wheels.
0helpful
1answer

04 Titan Does not stay on when cranked

if veh have malfuntion ligth on may be is the cranck possition sensor or the cam sensor, olso if there is no codes
is the IPDM ir intelylled power distribution module veh will cut off when running
0helpful
4answers

95 nissan pickup wont start

if u cant find any info about the diode try a used alternator should b cheap fix
Not finding what you are looking for?

959 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...