I have a 1988 toyota camry with power windows and the rear driver's side window is stuck in the down position. i have tried lots of thing to no avail -- i believe my next viable option is to take the door panel off and manually crank the window back up. i'm wondering if anyone can tell me the proper way to take the door panel off and do this procedure or if there are any other ideas.
To get to the Window:
Remove Door Inside Handle:
remove screw, slide the handle forward.
Disconnect the control link and remove the handle.
Remove Door Trim with Inner WeatherStrip:
Remove the two screws from the armrest.
Insert a screwdriver between the trim retainers and the door panel to pry it loose. Eight hidden fasteners. 1 top left side of door.
1 right side about same height as top of armrest. 1 (each side) about same height as bottom of armrest. 1 on each corner bottom. 1 bottom in middle. 1 on left side between bottom corner and the previous at about lower armrest height...
Remove Service Hole cover.
Remove Door Glass Run.
Remove Division Bar (upper window section divider):
Remove the two screws under the weatherstrip
Remove the bolt.
Pull out the division bar.
Remove the Window Glass:
Place the glass in the door cavity.
Remove the two glass channel mounting bolts.
Remove the window glass by pulling it upwards.
You now have access to the Power Window Regulator; possible replacement of motor etc.
What type of 'things' have you tried for fixing the window and restoring operation?
638 views
Usually answered in minutes!
i need to replace the front driver side window motor, are the directions the same as in this post?
×