Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Jan 11, 2013

2006 mitsubishi endeavor shutters at 40 mph - Endeavor Mitsubishi Cars & Trucks

5 Related Answers

Anonymous

  • 710 Answers
  • Posted on May 01, 2009

SOURCE: I have a 2006 Mitsubishi Endeavor. About two days

IT ALMOST SOUND LIKE YOUR CONDENSATION FROM YOU A/C UNIT IS STUCK IN THE DUCT AND THE FAN IS BLOWING IT AROUND. WITH YOUR A/C ON, SEE IF THE RUBBER HOSE THAT COMES DOWN OUT OF THE DUCT UNDER THE RIGHT SIDE OF THE VEHICLE IS CLOGGED. PUT A SMALL WIRE UP THROUGH THE HOSE AND CLEAR IT OUT. HOPE THIS HELPS. LET ME KNOW PLEASE. GOOD LUCK

Ad
ourhowse

Dar

  • 2007 Answers
  • Posted on May 21, 2009

SOURCE: 2004 GMC sierra 5.3 eng 1500 transmission shutter 40-55 mph

Try changing the fuel filter. I think it's starving for gas and the transmission can't decide what to do.

uortegon

  • 3 Answers
  • Posted on Jun 10, 2009

SOURCE: Cabin Air Filter - 2004 Mitsubishi Endeavor (Where?)

IT IS IN BEHIND THE GLOVE COMPARTMENT YOU HAVE TO TAKE IT OUT BY UNSREWING AND START FROM YOUR RIGHT SIDE

Anonymous

  • 131 Answers
  • Posted on Aug 14, 2009

SOURCE: does the 2006 Mitsubishi Endeavor have a fuel

yes it does, it is at hte top of the fuel tank.you need to drop the tank in order to get to it.make sure you drain the tank before you work on it.

lgbnme

Michael Koerner

  • 14 Answers
  • Posted on Oct 11, 2009

SOURCE: 2004 GMC sierra 5.3 eng 1500 transmission shutter 40-55 mph

I too have that problem. I own a 2005 GMC Yukon. Shutters between 40 + 55 mph. I thought for sure the stumble I felt was a plug or coil pack because it only does it under a load. With A/C on the whole truck shakes! But it wasnt the plugs or coil packs. Answers anyone?

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

My mitsubishi endeavor 2004 start to shutter on the right front between the speed of 20 to 40 mph what could cause that

It sounds to me like you have a wheel that's not balanced correctly. Did you get new tires recently? If so, take it back to the tire shop and get it rebalanced.
0helpful
1answer

Loud noise in engine of 2004 endervor

I would like to hear the noise.so I can have a idea what it is .please
0helpful
1answer

Car shimmy's at 40 mph

Could be a number of things, bent wheel, balance weights fell off. bad ball joint, tie rod, steering stabizer or pitman arm. Possible bad wheel bearing.
0helpful
1answer

Strange sound from mitsubishi endeavor

Exhaust manifold cooling off.
It's normal .
1helpful
1answer

My ignition keys come apart from the remote

You could try the following...

Without keyless entry ($20):
https://www.ikeyless.com/vehicles/mitsubishi/endeavor/2006/product83493

With keyless entry ($100):
https://www.ikeyless.com/vehicles/mitsubishi/endeavor/2006/product83494
0helpful
1answer

Low speed shudder as well

always start with the basics,fuel filter,sparkplugs,air filter
4helpful
3answers

I have a low speed shudder that is around 30-40 mph. I have had this occur in the past and changing the transmission fluid makes it go away. I have 160,000 miles on 2004 Endeavor that is just about 6 years...

DO NOT USE ANY OTHER FLUID OTHER THAN MITSUBISHI FLUID!!!! Any other fluid other than Mitsubishi fluid will blow the torque converter these transmission are very picky. Have a COMPLETE fluid tranny flush with Mitsubishi ATF Fluid. If your truck is an AWD that had a recall on the drive shaft, if you have an AWD and did not experience this before you have just been lucky and now had your luck run out at 160K. I would however put my money on the use of non-Mitsubishi transmission fluid.
Not finding what you are looking for?

82 views

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...