Interior lights and exterior parking lights and tail lights dont work and all the fuses are good

Look for a bad earthing point on the chassis near the headlamp loom.

What about them ? What front lights ? Headlamps , park lamps, marker lamps ? They don't work ?

Exterior Lamps
The exterior lighting system consist of the following lamps:
• The Headlamps
• The Daytime Running Lamps (DRL)
• The Clearance Lamps (Y92 roof rack only)
• The Cornering Lamps
• The Front Fog Lamps
• The Rear Fog Lamps (Export)
• The Park, Tail and Marker Lamps
• The Turn Signal Lamps
• The Stop Lamps
• The Backup Lamps

Park, Tail, Marker, License, and Clearance Lamps
The park, tail, marker, license, and clearance (Y92 only) lamps are turned on when the headlamp switch is placed in the PARK or ON position or anytime the headlights are requested. The I/P BATT fuse in the engine wiring harness junction block supplies battery positive voltage to both the park lamp relay switch contacts and the park lamp coil circuit. The body control module (BCM) provides a ground or control circuit to the park lamp relay coil circuit. When the park lamps are turned on, the BCM energizes the park lamp relay. Current flow is from the park lamp relay to the individual park lamp circuit fuses and to their respective park, tail, marker, and license lamps. The front park and marker lamps are grounded at G107 and G103. The tail lamps are grounded at G401 and G402. The license lamps are grounded at G401. When equipped with the Y92 roof rack option, the clearance lamps are grounded at G302. If the driver places the headlight switch in the ON position after the ignition switch has been turned OFF, the park, tail, marker, license, and clearance lamps will remain on until turned off or the battery runs dead.
The T PARK fuse in the rear fuse-relay block supplies battery positive voltage to a separate park lamp circuit connected to the trailer wiring harness.

Search Results

Tail - Running Light Testing - Professional Mechanics Online

www.2carpros.com/.../no-tail-lights-exterior-running-lights-tail-lights-ou...
Aug 1, 2015 - Begin with the car on level ground, engine off with the parking brake set, wear ... Step 10 - If all running or tail lights are not working, a fuse is used to ... light and test for twelve volts at the rear of the headlight switch connector ...

No. Dash lights being out could be a bad headlight switch, since the dash lights are routed through the headlight switch, not the dimmer switch. Park and tail lights also controlled by the headlight switch.

I had this problem with my 2007 Honda CRV -- all the lights worked EXCEPT the tail/running lights and the license plate light. The other tail lights worked -- brake, reverse, indicators, and hazards. Front headlights also worked, but when the headlights went on the back tail lights did not (not to safe for driving at night!!)
The fuse was #15 in the interior fuse box (under the dash driver side) with the label "small exterior lights" ( also check fuse #19 labeled "small lights main"). The cause of my problem, I believe, is a bad or lose wire in my license plate light.

possible lite switch needed

Sounds like it could be the headlight switch.

If its just the lights, then probably the headlight switch. If radio problem is related then possibly a bad ignition switch.

Having the same issue somewhat. Tail lights and dash lights quit. Checked the headlight switch wiring harness by looping all other prong holes back to the main power and they all work, so mine must be the switch. Having a real hard time finding a switch that matches the old one, even though they say it is a replacement. I paid the $25 at www.alldatadiy.com and they have quite a few wiring diagrams for the car.