Location of crank position sensor on 92 chevy corsica 3.1

2.8l? ignition module or crank position sensor.

chevy corsica 3.1L crank sensor is located on the front of the engine above the starter.

probably has a crank sensor on the back side of the motor toward the tranny, if not bolted on the tranny bellhousing. if that thing goes bad, it wont fire. it should have 2 wires going to it and usually one bolt holding it in.

This is usually a sign of a bad crank position sensor. You can find a detailled tutorial on testing and removal at the autozone.com web site. Log in as a member and look up crank position sensor for your car.

The sensor is located Under hood, center, rear engine area, below ingnition coil pack and DIS module, mounted in engine block. It has the small elec. connecting plug.

i think you mean a crank shaft position sensor witch is located on the back of the motor towards the bottom. good luck

Ignition module may be bad. It should be located under the coils, the coils usually plug into the ignition module. Also might be a bad crank or cam sensor

its located right behind the balancer. remove the balancer you will see the shield remove the shield and the sensor is located right behind it secured by a bracket.

front of engine just about 11:00 over crank pullry

wall5552: there were two engines used in 1992 Jeep Wranglers.
A 2.5 liter and a 4.0 liter. HOWEVER>>>> The location for the crank angle sensor is the same for both.
It is located on the bell housing up near the front at about the 10:00 PM position.
The Cam position sensor is located in the Distributor on both engines as well.