My 95 gmc suburban had a broken mirror which was replaced. When mirror was installed, it was tested and both the right and left mirrors worked..Soon after they both stopped and the plug to the switch was checked and there was no fire going through either wire..All the fused in the fuse box were checked and are fine..but still no fire to the mirror switch...Help...
SOURCE: Need to replace the broken outside right passenger mirror I have replacement
To repace the COMPLETE MIRROR UNIT, the inside door trim must be removed. Hope this helps
SOURCE: No brake lights on 95 Suburban
Disconnect electrical connector to brake switch brake located near brake pedal. Check for twelve volts or power with a test light on one side. If power, get a piece of wire, strip the ends and plug into each end of connector. If brake lights works, switch is bad. If not, check bulbs and power in the brake light socket. If no power, check to make sure power is leaving the trafficator switch as the brake light switch is depress or bypass. Check for broken or bad connection along circuit. If all good, you could have a trafficator switch problem. Oh, are the hazard and trafficators working in the rear? If they are, the trafficator switch is bad because the brake switch sends power there, then out to the back through the left and right rear trafficator wires.
SOURCE: need to replace Mirror Assembly, 03 suburban
Your going to have to remove the inside door panel to get to the three bolts that hold the out side mirror assembly. Once you have the door panel off you'll see the three bolts that hold the mirror assembly, just un-bolt and un-clip the wire harness to the electric/heated mirror. To install the new mirror assembly, just do everything in reveres. Go to Auto Zone and by extra door panel clips, there is a good chance of breaking some of the retainer clips and Auto Zone will have the step by step instructions to replacing the mirror assembly and the removal to the door panel. Good luck and keep me posted. Be glad to help.
SOURCE: How to replace power, heated, folding door mirror
driver side power mirror won't move up or down. will move side two side.
SOURCE: Replace passenger side electric mirror
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
Power Dr Mirrors Diagnosis & Testing
Fig. Removing cover trim and nut
Removing cover trim and nut
Fig. Removing mirrored glass from assembly
Removing mirrored glass from assembly
Fig. Removing connectors and screws holding mirror motor
Removing connectors and screws holding mirror motor
Fig. Reattaching mirror and electric motor connectors
Reattaching mirror and electric motor connectors
230 views
Usually answered in minutes!
×