SOURCE: blower for nissan titan
The picture I will try to attach will show you the blower motor housing. The white electrical harness rt hand upper corner is attached to the blower motor resistor. If you have checked the relay and its working ( you can check with a tester) the resistor is probably the problem. It's the most common a/c blower issue I see weekly hope I can send it and hope it helps.
SOURCE: starter
The starter on the 5.6 L engine is located at the top of the transmission bellhousing. You have to remove the upper intake plenum to get to the starter. You can't really see the starter until the plenum is out of the way.
Hope this is helpful!!
Nissan Scope Technician- 10+ years experience in Nissan dealership
SOURCE: 2005 altima fuel pump
The tank does not need to be dropped. There is a access panel either under the cushion of the rear seat or in the trunk. I have to replace the pump on my 02
SOURCE: how to change fuel filter in 2005 nissan titan
From the information I have been reading the fuel filter is located inside the tank and is part of the 100k-150k maintence period.
SOURCE: HOW TO REPLACE A FUEL PUMP FOR A NISSAN XTERRA
Removal & Installation
Negative battery cable
Fuel pump module harness connectors
Filler hose shield
Fuel pressure and return lines
Filler hose
Vent hose
Evaporative Emissions (EVAP) hose
Fuel tank skid plate
Fuel tank
Fuel level sender
Fuel pump
To install:
Fuel pump
Fuel level sender. Tighten the screws to 17-23 inch lbs. (2.0-2.5 Nm).
Fuel tank. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm).
Fuel tank skid plate. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm).
EVAP hose
Vent hose
Filler hose
Fuel pressure and return lines
Filler hose shield
Fuel pump module harness connectors
Negative battery cable
118 views
Usually answered in minutes!
×