I buyed my Nissan Maxima from a third owner, and he didn't knew the code for the security panel on the front doors, for a more clear reference this code can be used to unlock the doors, open or close the windows, and open the trunk. By the way my automatic locks stoped working, first they started to fail ocassionally but later the problem became permanent.
SOURCE: 1991 Nissan Maxima: Removal of front driver side door panel
This is out of my haynes manual
1 disconnect negative battery cable
2 on manual window equipped modesl remove the window crank using a hooked tool to remove the retainer clip.
3 on power window equipped models pry out the armrest switch control plate and disconnect the electrical connections
4 detach the armrest pull handle retaining screw then remove the inside door handle trim bezel
5 insert a wide putty knife, a thin screwdriver or a special trim panel removal tool between the trim panel and the head of the retaining clip to disengage the door panel retaining clips.then remove the remaining door panel retaining screws at the lower edge of the door panel.
6 once all of the clips are screws are disengage detach the trim panel disconnect any electrical connectors and remoe the trim panel from the vehicle by gently pulling it up and out.
7 for access to the inner door remove the door panel support bracket then peel back the watershield taking care not to tear it. it install the trim panel first press the watershield back into place. if necessary add more sealant to hold it in place.
8 installation is the reverse of removal
SOURCE: Driver side window stuck on Nissan Maxima 2004
It is likely the window motor is wearing out and will need to be replaced. You can always try a different switch on those wires to rule out switch problem. Otherwise, the motor will have to be replaced.
62 views
Usually answered in minutes!
×