1994 Camry wagon, passenger side electric window.(front seat)

It sounds like the motor on that door went bad! Each door has an individual motor to control the window..

more than likely one of the switches are bad (down side of switch works but up side of switch dont) being as the switches are wired together if one goes bad other one won't work either take the switch out one of back doors should be same as front passenger door put rear switch in front passenger door if works then u know front door switch is bad if it doesn't then drivers door switch is bad
u replaced window regulator Did that come with motor too??? if not check to see if motor is good
there is two wires going to motor cut isolation back on wires and using some jumper wires attach one wire to positive terminal of a 12 volt battery attach other wire to negative terminal of battery window should move up or down reverse connections and window should move other way

FOr 1994 Toyota Camry 2.2L EFI DOHC 4cyl the Engine Control Computer is located: Front seating area, passenger side, under dash, mounted behind kick panel.



Components locations-1MZ-FE engine (click for zoom).

I hope helps (remember to rate this).

Before bolting on the regulator bracket, insure the glass is properly seated on the side rubber guides.

only the front driver side dont work

replace ur power window switches

More than likely, you have a broken wire or two between the body and the driver side front door. This is a very common issue with those cars when tey get older.

Perhaps an item got caught under the seat and possibly affected the linkage wire between rail tracks.A small linkage wire trips the console side track.Without this,that particular track will not disengage.Look under the good working passenger side seat and you might notice this linkage wire.It will then give you an opportunity to see if it works well on the inop seat. You can pull that wire(or trip that linkage arm by hand if you are in a dilemma and need the seat moved in order to drive but use caution on these moving parts and dont get pinched.

Its time to stop being afraid of the unknown. there is no doubt that you will need to remove the inner door panel to access the electrical modules behind the buttons. https://www.youtube.com/watch?v=p2_f7NkjH8E hope this helps.

you sre looking at replacing the window motor it is just to week to rase the weight