2005 Toyota ECHO Logo
Jan M. Brady
Jan M. Brady Posted on Jan 07, 2013
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

P1300,p 1305,p1310,p1315 how do i fix these fault codes on a Toyota echo 2005.

Answer This Question

2 Answers

Lodhi Autos

Lodhi Autos

Level 3:

An expert who has achieved level 3 by getting 1000 points
Superstar:

An expert that got 20 achievements.
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.

  • Toyota Master 992 Answers
  • Posted on Feb 16, 2014
Lodhi Autos
Toyota Master
Level 3:

An expert who has achieved level 3 by getting 1000 points
Superstar:

An expert that got 20 achievements.
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.

Joined: Feb 03, 2013
Answers
992
Questions
1
Helped
590217
Points
1808

P1300 Igniter Circuit Malfunction / 14
P1305 Igniter No. 2 Circuit Malfunction / 15
P1310 Igniter No. 3 Circuit Malfunction /15
P1315 Igniter No. 4 Circuit Malfunction

p1300,p 1305,p1310,p1315 how do i fix these fault - 444a5478-5b0c-4e6e-8a98-e031ba8bc972.png

Jibrael ali

Jibrael ali

Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on May 10, 2015
Jibrael ali
Contributor
Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

Joined: May 10, 2015
Answers
1
Questions
1
Helped
7517
Points
3

You got this fixed?i am having the same problem.

Ad

3 Related Answers

Anonymous

  • 1 Answer
  • Posted on Dec 19, 2010

SOURCE: i have error codes of p1300,p1305, p1310, p1315,

P1300 = ignition system malfunction (#1 coil/igniter circuit fault)
P1305 = same as above but #2 coil
P1310 = #3 coil
P1315 = #4 coil

Ad

Anonymous

  • 1861 Answers
  • Posted on Nov 20, 2008

SOURCE: occasionally stall & engine check light on.code read p300 misfire

Sent is just now. Let me know if you get it. GLad to help, and Thanks for choosing FixYa!

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Sep 01, 2011

SOURCE: I have a 2001 toyota

Hello
The OBD2 fault code you need to be concerned with is the P0304 (I would ignore the P1310,P1315 for now), this fault code indicates you have a engine Misfire in engine cylinder #4 at some time, this will be the hesitation you fell. I don't know the miles on the car but I would replace the spark plugs and the #4 Ignition Coil (this system has a separate igntion coil for easch cylinder), that should take care of the problem, it is the most common reason for this type of Hesitation. Clear the code after the pugs ands wires are replaced by disconnecting the negative cable of the battery for 5 minutes and drive it a few days to see if the problem is repaired. Below is a picture part number and price for a new ignition coil, it is located in the vlave cover and goes down into a well, the spark plug is at the bottom.






Here is the technical information on fault.

P0304 - Cylinder 4 Misfire Detected.
Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
- Lack/loss of power
- Hard start
- Engine hesitation
Possible causes - Faulty spark plug 4
- Faulty ignition coil 4
- Ignition coil 4 harness is open or shorted
- Ignition coil 4 poor electrical connection
- Clogged or faulty fuel injector 4
- Injector 4 harness is open or shorted
- Injector 4 poor electrical connection
- Improper spark plug 4
- Insufficient cylinder 4 compression
- Incorrect fuel pressure
- Intake air leak
emissionwiz_217.jpg (parts price source is www.rockauto.com) STANDARD MOTOR PRODUCTS Part # UF247 Price $73.89 USD The spark plug number you need is: DENSO Part # 3120 Price $1.47 each (4 required) Spark Plug Gap 0.044"

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Japanese Model Toyota Mark II GX110 is Giving Code 15 and P1305, P1310.
Question edited for clarity. This is not a North American model.

Code 15 is cumulative for the 2 Codes

15 - Ignition system, coil No. 2 (P1305) and No. 3 (P1310)

P1303

P1310 TOYOTA Code - Igniter Circuit Malfunction No. 3

 https://www.engine-codes.com > p1310_toyota
The P1310 code is for the ignition coil No.3 and is set when there is no IGF signal to the ECM during engine operation. 'What are P1310 TOYOTA code possible ...

P1310 TOYOTA Code Igniter Circuit Malfunction No. 3

https://www.autocodes.com > p1310_toyota
The P1310 code is for the ignition coil No.3 and is set when there is no IGF signal to the ECM during engine operation. 'What are P1310 TOYOTA code possible ... P1305

http://enginedtc.com/p1305-toyota-mark-ii
Read full answer
Aug 17, 2022 • Toyota Cars & Trucks
1helpful
1answer

2001 tacoma codes p1300,1305, 1310,1315 igniter malfunction what does this mean?
Check this link out. DTC P1300 Here's a video. Toyota Injector Coil Replace Fault P1315 Engine Light Turn Off iCarsoft...
Read full answer
Jul 24, 2017 • Cars & Trucks
0helpful
2answers

P1300,p 1305,p1310,p1315 how do i fix these fault codes on a Occasionally stall & engine check light on.
You have an at times fault which is loss of spark on all four cylinders. Worse case is the engine control module (quite expensive) so lets keep that for last cause. If it were to fail it would more than likely 100% of the time. Therefore the most likely causes are either a dirty connector or loose ground. See image 1&2 below to uncover coil on plugs. locate connector plugs common to all four plug wires. There are two junction connectors A & B. With key off remove connectors, check for bent pins and spray with DOXIT a radio shack product that is a great No Touch pin cleaner. Replace connectors. One wire from each of the four coil on plug wires leads back to the ECM (Electronic Control Module) Connector A (it is labeled). disconnect and perform same procedure using spray. Reconnect...you'll need to clear codes by disconnecting positive battery terminal for 3 minutes. Test run vehicle to see if troubles have cleared...If not; do you have a multimeter and a wee bit of experience using one? If so put on lowest ohm setting...Hold one terminal on the negative battery terminal...right on the post...Hold the other on bare metal of chassis as in fender...record reading...While holding lead on battery terminal move the other lead to metal of engine block...record readings...Must be close to zero ohms about 1 to 200...If readings are around 2000 ohms the car has an inadequate ground...If so send me a [email protected]
25689133-it05lymtu1334i4my0oofgx5-1-1.gif

25689133-it05lymtu1334i4my0oofgx5-1-3.gif

p1300-p-1305-p1310-p1315-fix-fault-codes-fsiw50wukvgddzmkmreyzoen-5-3.gif


I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Read full answer
May 10, 2015 • 2003 Toyota Corolla
1helpful
1answer

How to fix the the p1300 p1310 codes to a Toyota Camry 2001le4cl
Ok for code p1300 replace ignition coil 1 and 4 cilynder and for p1310 replace ignition coil 2 and 3 cilynder
Read full answer
Mar 03, 2015 • Toyota Cars & Trucks
0helpful
1answer

Code p1315
DTC P1315 is Igniter Circuit Malfunction (No.2).
Check No. 2 ignition coil.
See the link below for more information from a 2000 to 2002
Toyota Echo Service Manual.
Diagnostics: Engine: P1300, P1305, P1310, P1315 Igniter Circuit Malfunction (Echo)

Hope that helps.
Read full answer
Sep 19, 2013 • 2001 Toyota Echo
2helpful
1answer

Check Engine light on 2005 Toyota Echo, Code P0012
Error Code: P0012

Fault Location:

Camshaft Position (CMP), Intake/Left/Front, Bank 1 - Timing Over-Retarded


Possible Cause:

Valve timing.

Mechanical fault.

Camshaft position (CMP) actuator.

Intake Camshaft Adjuster tight/stuck.

Intake Camshaft Adjuster faulty.

Possible Solutions:

Check Intake Camshaft Adjuster.


Check valve timing.

Check the timing gears.
Read full answer
Sep 28, 2012 • 2005 Toyota ECHO
0helpful
1answer

I am getting codes P0300, P0302, P1300, P1305 and P1310 - I recently replaced the spark plugs (less than a week ago). Thinking it might be the coil in cylinder 2, I purchased a new one and installed it...
What is P1300,1305 1310 on a Toyota

They are MFG Specific

Get them and I will try and offer some suggestions

302 is #2 but Iam thinking if you find that
those other codes are Cam Sensors, then
we will discuss that
Read full answer
Mar 19, 2011 • Toyota Corolla Cars & Trucks
1helpful
1answer

My Toyota Echo 2005 light up checkengine light 80000 milles How resolve that problem? Thank, Fernando
Get an OBD-II Scanner to scan the codes off of the computer. One can get one for under $100 from Sears or Walmart. Or go to autozone or advance auto parts and get it scanned for free.

After getting the codes, the system that is failing will be apparent, and parts should be changed or adjusted in that system.

The light can sometimes be erased or turned off by the scanner, if the fault that caused it is gone.
Read full answer
Nov 10, 2010 • 2005 Toyota ECHO
25helpful
2answers

I have error codes of p1300,p1305, p1310, p1315, on my toyota an am looking for the deffinations and issues thse codes create. I have a 2002 tacoma.
P1300 = ignition system malfunction (#1 coil/igniter circuit fault)
P1305 = same as above but #2 coil
P1310 = #3 coil
P1315 = #4 coil
Read full answer
Oct 31, 2010 • 2002 Toyota Tacoma
0helpful
1answer

Occasionally stall & engine check light on.code read p300 misfire
Sent is just now. Let me know if you get it. GLad to help, and Thanks for choosing FixYa!
Read full answer
Nov 19, 2008 • 2000 Toyota Corolla
Not finding what you are looking for?

View Most Popular

2005 ECHO

  • Cars & Trucks

Related Question

Japanese Model Toyota Mark II GX110 is Giving Code 15 and P1305, P1310.

  • Toyota Cars & Trucks

Related Topics

7,527 views

Ask a Question

Usually answered in minutes!

Popular Questions

Have codes P0441, P0442, and P0446. What could be

2003 Toyota ECHO

How do you fix an Igniter Circuit Malfunction -

2002 Toyota ECHO

Toyota ECHO REAR DOOR HANDLE problem

2001 Toyota Echo

Location of fuel filter on toyota echo 2000.Is

2000 Toyota ECHO

Where is the fuel pump relay on toyota echo

2001 Toyota Echo

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. 2005 ECHO Manual

2005 ECHO

Loading...