Can anyone show me where that part is p1167

SOURCE: what is a 112 and a 444 code on my hyundai santa fe

Code PO 112 is intake air temperature circuit low input and PO 444 is Evaporative Emission control system purge contol valve circuit open. Both codes could be sensor problems or wiring problems.

Marvin

• 85242 Answers
• Posted on May 22, 2009

SOURCE: PROGRAM KEYFOB FOR HYUNDAI SANTA FE

This is from the factory service manual of your car:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Translation you need the dealer to do this.

SOURCE: where is the trans speed shaft sensor on a 2001 hyundia santa fe?

There are two speed sensors, Input sensor is located on top of the bell house. Output sensor is located on the firewall side of the bell house.

SOURCE: How do you put a spare tire back under a 2001 santa fe?

there is a hole in the trunk area for a large common blade type screw diver that loosens or tightens the spare tire platform

SOURCE: 2001 hyundai santa fe has

Trouble Code: P1167

HO2S-11 Controller Adaptive Test (Bank 2)
Possible Causes:


Air leaks after the MAF sensor, or in the EGR or PCV system Base engine "mechanical" fault affecting one or more cylinders Exhaust leaks located in front of the A/FS or HO2S location Fuel control sensor is out of calibration (i.e., ECT, IAT or MAP) Fuel delivery system supplying too little fuel during cruise or idle periods (e.g., faulty fuel pump or dirty, restricted fuel filter) Fuel injector (one or more) dirty or pressure regulator has failed HO2S is contaminated, deteriorated or it has failed Vehicle driven low on fuel or until it ran out of fuel Please let me know if you have any questions