Fuse keeps blowing to my dash guages in my 95 gmc sierra why?

SOURCE: Timing off, advancing 20' 95 GMC Sierra 350 cu.in.

after connecting your wire try resetting your distributor or pull timing chain cover and ckeck timing marks on gears

dave smith

• 94 Answers
• Posted on Feb 27, 2009

SOURCE: 1998 chevy malibu fuse question

Sounds like you have a ground problem, i doubt its in the sending units as both gauges are acting strange work, seeing that electricity likes paths of least resistance one gauge could be grounding through another. Bad grounds wreak havoc on electrical systems.

SOURCE: taillight fuse keeps blowing, replace bulbs,

check to see if anybody has put a aftermarket plug on the left rear corner of the under the bed for trailer light, they short out and cause fuses to blow also make sure the wiring is not rubbing on the frame and cutting the insulation

SOURCE: It keeps blowing the ECM Fuse, checked wiring but

My friend;
Try this;

1. Did you insert same valued fuse i.e. { fuse rated 15APS with same fuse}.
2. Check OP'S & voltage of the Alternator = 13.7 V DC - 14.8 V DC MAX.
3. are you sure NO internal shorttings inside the ECM.

SOURCE: 1996 chevy s10 blazer 4x4 keeps blowing taillight

somewhere afterthat fuse is a dead short, not much fun but its detective work from here, it helps if you have a wiring diagram and could save you time