1999 Porsche Boxster Logo

Related Topics:

JOHN TAILBY Posted on Dec 28, 2012

How to remove porsch boxter washer bottle

Need to remove water bottle

5 Related Answers

alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on Nov 17, 2008

SOURCE: 2001 PORSCHE BOXTER ALARM WILL GO OFF INVOLINTERY WHEN SET?

disconnect the alarm

Ad

Anonymous

  • 2 Answers
  • Posted on May 28, 2009

SOURCE: 2001 porsche boxter engine running hot

My 2000 Boxster developed a pin hole leak in the coolant reserve tank in the rear trunk. The trunk floor is actually raised, which allowed the coolant to go unnoticed, since the carpet never got wet. I would pull back the carpet on the side and see if there is coolant in the trunk area. If so, the plastic reserve tank will run you about $300 for the part. It is a bit of a pain to replace, but something the average home mechanic can do. Only real hassle was the hose clamps in the engine bay were installed before the engine, hence the engine was in the way of the screw head.

Anonymous

  • 52 Answers
  • Posted on Sep 06, 2009

SOURCE: Porsche Boxter rear luggage compartment lid pull-button problem

remove the two plastic bungs in the side of the cover panel down side of seat, then inside are two 6mm allen screws, these need to be loosened, not removed to allow the trim to be lifted up to access switches. refitting is reversed

Anonymous

  • 52 Answers
  • Posted on Sep 06, 2009

SOURCE: how to open/access Porsche Boxter engine (2000)

lower hood back until front edge of hood is above drivers head when seated in car, then release cables holding rear edge of hood to body (one each side clipped onto two ball joints, and unclip long plastic rain channel along rear of hood. lift rear frame/rear window up to vertical behind driver. remove compartment and carpet held by four 1/2 turn screws to uncover engine cover, this is released by turning locking clips 1/2 turn

Anonymous

  • 52 Answers
  • Posted on May 08, 2010

SOURCE: i need a radio code for my 1999 porsche boxter

The following site will help you recover your radio's serial number and code: http://www.a2dvoices.com/realitycheck/porsche/

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

How do I open a 1999 porsche boxter front trunk with a battery that has been disconnected for storage?

Raise and support back of vehicle ,next the gearbox you find the starter, clamp an electrical wire to the 13 m.m. Bolt in the startersolenoid I mean to the big cable and connect the other side of wire to car battery + and clamp a wire from the battery - to the gear box or anywhere ground now you can open the trunk
0helpful
1answer

2000 Porsche boxter windows work top won't go down

Good Day,
I just looked at my wiring diagram and see that a fuse from fuse Holder D, Fuse D3,it is a 30amp fuse. I would start here. I may also be a good idea to have a test light if you plan on doing your electrical repairs.

I also see that another fuse connects to your top control unit; it will be fuse B6, 15amp located in fuse Holder B.

Thanks and good luck.

Rodney
0helpful
1answer

I have a dead battery on my 2002 Porsche Boxter and can't open the hood to jump it. How do I open the hood with a run down battery?

Hello there

In your right front fender is an "emergency operating cable" to open the front hood.
To get to it you need to remove the fender lining and there next to the rear of headlight is the cable.

proporsche
4helpful
1answer

In need of torque settings for a porsche boxter

moisten bolts with engineoil,
1st step tighten to 23 ftlb
2dn step loosen all bolts
3rd step tighten to 15 ftlb
4th step add 60 dgrees
5th step add 60 dgrees
4helpful
1answer

I need a radio code for my 1999 porsche boxter

The following site will help you recover your radio's serial number and code: http://www.a2dvoices.com/realitycheck/porsche/
0helpful
1answer

Porsche Boxter rear luggage compartment lid pull-button problem

remove the two plastic bungs in the side of the cover panel down side of seat, then inside are two 6mm allen screws, these need to be loosened, not removed to allow the trim to be lifted up to access switches. refitting is reversed
13helpful
2answers

How to open/access Porsche Boxter engine (2000)

lower hood back until front edge of hood is above drivers head when seated in car, then release cables holding rear edge of hood to body (one each side clipped onto two ball joints, and unclip long plastic rain channel along rear of hood. lift rear frame/rear window up to vertical behind driver. remove compartment and carpet held by four 1/2 turn screws to uncover engine cover, this is released by turning locking clips 1/2 turn
Not finding what you are looking for?

301 views

Ask a Question

Usually answered in minutes!

Top Porsche Experts

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...