Location of knock sensor . 2006 toyota solara 2.4 engine .
ON ENGINE BLOCK BELOW THE HEAD & EXHAUST MANIFOLD ON SOME VEHICLES.
SOURCE: Location of knock sensor on 1994 toyota 22vre engine
The Knock sensor on a 22re is located under the intake manifold on the engine block. to the upper left of the oil filter. With is the passenger side of the engine. I believe it is yellow in color. Not do be confused with the oil pressure sensor which is close by. The knock sensor has a larger electrical connector. Good luck it can be hard to get to.
SOURCE: vsc vsc off check engine
Disconnect your battery for 10 minutes after which you connect it back the lights should go off. Don't report to toyota. Nigerian style!
Rate this............
SOURCE: Need to locate knock sensor on 1999 camry V6. Where is located.
i have toyota windom 4vz-fe i need locate knock sensor
SOURCE: Locate O2 Sensors
Hello mail4rj: My name is Roger and I will help you. Bank 1 sensor 1 means the cylinder head with #1 cylinder located in it. B2S1 is the cylinder head opposite the #1 cylinder. Basically locate the oxygen sensors in front of the catalytic converters and you will have the sensor you asked to locate. Any sensors behind the converters would be wrong. Should you need further help please just ask. Please rate the answer you received. Thank You for using Fix Ya. Roger
SOURCE: 2005 Toyota Camry - knock sensor
Your sensor went off because it overknocked.
Try using a different type of fuel with a higher octane.
Erase the code and use the better gas. if it comes back then we will worry about replacing it.
Knock Sensor Circuit Malfunction
What does that mean?
A knock sensor tells the engine computer when one or more of your engine's cylinders are "knocking", that is, exploding the air/fuel mixture in a way that delivers less power and can be damaging to the engine if prolonged. The computer uses this information to tune the engine so that it doesn't knock. If your knock sensor wasn't operating properly, so that it was always indicating a knock, the engine computer's response may have been to change the ignition timing on your engine. Knock sensors generally bolt into or thread into the engine block. This P0325 code may show up intermittently or the Service Engine light may be lit constantly. Other knock sensor related DTC codes include P0330.
FB.init("dd7d9e9681341cde77587bc6a2029f6f");
OBD-Codes.com on Facebook
Symptoms
You may notice drivability problems including a lack of power and perhaps some hesitation. There may also be other symptoms.
Causes
A code P0325 most likely means one or more of the following has happened:
635 views
Usually answered in minutes!
×