I have gotten the code from the dealer and previously it worked. Recently had a dead battery, and double checked the code with the dealer and now it won't work. The code I enter just sits there on the screen. I have tried changing the fuses and almost all other fixes I have seen on the net. This is driving me absolutely barmy. Please someone help!
Unhook the battery for an hour or so to fully clear any previously bad entry attempts. hook battery back up and try the code again
SOURCE: where do you find the radio code 1994 saab 900
Upon disconnecting the battery the radio will flash code until you enter the code. If you enter the code incorrectly you must either hold the band button down until the word code reappears or leave the key on for one hour until the word code reappears. This procedure depends on the year of the car. If you do not have the radio code and would like to get it you must call your local Saab dealer with the serial number off the top of the radio. Many times radio owners will write the radio code on top of the radio once you have the correct code. Typically the radio code is in the owners pouch and is a small card with the numbers on it.
NOTE: If this helps you, please, please give me a good rating!!
SOURCE: I changed the battery on my 1997 Saab 900. Radio is dead.
turn on the radio and enter the code. If it does not respond, hold the band button down until the screen asks for it. If that does not work, pull the radio and courtesy fuses for 5 minutes and retry.
SOURCE: anti theft radio code wont accept number. radio wont work
Disconnect the negative terminal on your battery and reconnect after 10 seocnds. That should reset the radio and you can enter the code.
SOURCE: Can't get CODE IN on the screen
I have had this problem more than a few times. First you need to connect the negative cable last and when you do, try to connect it fast. For some reason if the connection sparks it doesn't seem to work that well. Second when you do connect it, go right into the vehicle and put the ignition key to the on position. Press the power button and the Code In should appear.
I don't know if you have the CD changer in the back although I have had problems with that too: Sometimes It dose not work properly after a reconnection. What I have done is unplug the CD changer cord from the changer until it works. For some reason its a pain in the ****, but if you keep at it it should turn on. Just remember that you have to have the radio on when your doing it.
SOURCE: Saab 900 1996 trying to put in radio code, I turn
You have to find the correct code entry instructions for your radio.
This will depend on the radio make + model
Check free instructions here
http://www.radio-code.co.uk/code-entry-help.php
263 views
Usually answered in minutes!
×