SOURCE: glove box latch broken
The latch is sold seperately. Call your local dealer with the last 9 of you vin number to get the right color. Most dealers sell at the same MSRP price as all the others in town. I know cause I sell these all the time at my Chrysler dealership.
SOURCE: driver's side door latch wont open door from inside
Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.
SOURCE: glove box latch broke close. How to open?
Hi, how are you? From what you are describing the latch on the inside sounds like it has broken and is not releasing. You can try to lay on the floor and look up in the bottom of the back of the glove box there are two tabs one on each side. If you push these tabs inward the bottom of the box should come free and help the top to come free. If you cannot see the tabs or can’t get the tabs pushed in, you are going to have to force it open, you can do this with a flat pry bar, wrap the end with a cloth to protect the paint. The good news is that the glove box latch is pretty cheap to replace.
SOURCE: The rear latch/handle on our
Here's how I repaired mine. Go inside and remove the plastic 2" square plastic cover. By pushing on the lever inside this area, the latch will release. Push on the door at the same time, when the latch is pushed. With the door open, remove all four screws from the plastic panel. Now pry carefully the big plastic panel off the door. There are plastic snaps holding this on, all around the edges. Now there is another metal cover over the latch mechanism under this panel. Remove this. You now can see into the latch area and put the handle back into the slot where it came out of. You'll see that the ends of the handle can be put back on the round bar, but to hold them in place, I attached 2 nylon ties on one end. You can also purchase a metal push on retainer from the local hardware store. Mine has been repaired for 8 months and had no trouble. Ford used no retainer on these handles and after prolonged use, they bend and the handle can be pulled off. A twenty minute job. Your wife can even do it.
Fred C
430 views
Usually answered in minutes!
×