The EGR was completely removed, I'm replacing it. I have all the necessary parts, yet I can't find the female plug into which the Temp sensor matches up to. It must go to the EECC, but it's either been cut off or hidden. I need to know where to look and/or to which control panel it belongs. Thanks.
SOURCE: Where is the coolant temperature sensor located on 2000 Altima?
THE SENSOR FOR THE GAUGE IS ON THE HOUSING THE UPPER RADIATOR HOSE ATTACHES TO.
SOURCE: Clean EGR ports and replace EGR temp sensor.
Test the Temp Sensor. I have a 240sx and apparently these things are notorious for burning out. I am in the midst of replacing them so i can smog. Best idea is to get one at a pick and pull (make sure its good) and throw it on there. Otherwise you will be spending 110 bucks on a brand new one as opposed to 35 which i just got mine for. You may have carbon deposits in your EGR system, but that is common. Too much WILL effect your cars EGR function. You can check for blockage but sticking (try not to laugh) a rubber tube the bottom hose of the EGR and sucking whilst the engine runs. If it starts idling rough or dies, then your system is still clear enough for it to be functioning properly. Realize that this system works off of exhaust fumes, and IS prone to carbon deposits. I paid 170 bucks for a mechanic to tell me i needed to replace some stuff. Otherwise he would graciously only charge me 770 bucks to do it himself.
SOURCE: 1999 Nissan Sentra Cam Shaft Sensor:
yes cam sensor is located in the distributor best way is to replace distributor .you will need a 12mm wrench. and a Philips screw driver. first mark the position the base is at because its adjustable.remove the cap with wires still attached and move it to the side.remove the rotor in the center.remove the distributor. upon istalation of new one the slot at bottom of distributor only goes on in one position then reinstall rotor and the cap.
SOURCE: I need to replace the knock sensor in my 2000
it is located on the bottom section of engine, Just unplug it and it screws out fairly easy
SOURCE: 2000 nissan frontier knock sensor code & distributor
no but the knock sensor does send a signal the ecm and it will ****** or advance the distributor timing
158 views
Usually answered in minutes!
×