Where is the chevy lumina jack spot? - Lumina Chevrolet Cars & Trucks

empty or full of fuel.
if full , tell everyone around you to run for the hills.

There is no such thing on a 1995 lumina. What is the problem?

First remove the negative battery cable at the battery. My lumina was a little newer than yours but for me it was easier to do from underneath the car. So if you can run it up on ramps or jack it up and use jack stands that is what I would recommend. You just remove the wires and make note of which ones went where. Remove the mounting bolts and out it comes.

a few things tires out of balance-bad tire-rim bent-shock/strut bad-worn or loose front end component-ball joints-bearing/hub---if bad enough to shake/shimmy u should be able to see or feel problem under front end jack up car and with wheel on move side to side than up and down than in and out when u do this if u hear a clunk or see a part move that shouldnt [tie rod connection/ball joint etc] than u found problem

You must raise then engine high enough to remove the oil pan. Loosen motor mount bolts & remove them, jack engine up enough to remove pan or use a chain block. Use wood blocks to support engine at motor mounts. Good luck!

disconeccect the filler tube,place a floor jack under the tank,remove strap bolts, lower the tank a little, dicconect the electrictal,
lower the tank alittle more, disconnect the fuel lies,
lower the tank all the way and remove it!!!
put the new one in!!!

Not that bad, jack up front of car used jack stands, starter sit between radiator and engine, on engine block above oil pan, disconnect battery 1st.

jack up the back of the car a high as you can,support with stands,purchase high pressure fuel line tool a local parts store,about 12 bucks.use a floor jack with a 2'x2' piece of plywood to suppport the weight better,remove the two long straps holding it up,one bolt on each,toward the front of the car,lower just enough to get at the fuel line connections,use the tool to unlock the special clips,you can also use a couple of scribes,or small flat screwdrivers,to get them apart,disconnect the fill tube,the hose that you put gas in the car from.might have to open the gas flap,remove cap,if there is screws or bolts take them out,unplug the wire harness going to the fuel pump on the top of the tank,everything should be un-hooked,just slowley lower it down,and pull it out the back on the jack,the less fuel in it the the easier it is ,i have a 2000 lumina,same engine,doesnt even look like you have to touch the exaust at all,should be the same as yours,un-hook the negative battery cable before you start just to be safe,hope this helps

First make sure you have enough clearance to work on the vehicle you may need a jack or jack stands. Then make sure your tires are blocked and emergency brake is on then disconnect the battery. Theres two bolt securing the starter to the engine block and two wires running from the battery to the starter. take the wires off and when your ready reverse the steps........

unscrew the strut bolts and the four frame bolts unbolt the axles from the spindles take and unplug all the sensors disconnect the shift linkage cable but be careful with it high cost to replace and it is still a deal item them support the engine with a bar and chain jack up the car put it on jack stands far enough back that it is not on the frame loosen steering knuckle also disconnect power steering line let jack down the frame should fall with the jack remove frame out of the way take out the starter then remove plastic covers unbolt fly wheel bolt then unbolt trans put a jack under the tranny use a pry bar to move the tranny from the engine and lower trans.reverse to reinstall