How to install power window regulator and motor
SOURCE: Mazda MPV: how to raise power window manually?
Hi,
I just had this problem with my driver door window. I took the door panel off and discovered that the motor was burnt out by testing with a meter.
I called around and found a motor at a junkyard for $135 dollars! I didn't bother looking at the price for a new one yet. Budget is very tight right now.
Like you I just wanted a way to get the window up until I could get around to replacing the part.
You can find out what I did with pictures here.
This is for the front driver side window. I did the same for the rear passenger side window and the steps are fairly similar.
There are few less steps to getting the panel off, but it was a little trickier to get the panel back on. (The key was to pull the bottom out and start at the front: Lower the forward part of the panel over the top of the frame first - while pushing firmly at the top of the panel).
The steps for disengaging the motor and raising the window with the motor re-engaged are almost the same. The only differences are that the motor is in a different position in the frame. It's down near the bottom of the frame - and seemingly inaccessible at first glance.
However, if you disconnect the motor from the frame and let it dangle on the regulator wires, you can pull it all the way through to the other port in the frame. That way, it turns out that, it was even easier to work with than the driver window motor.
Hope this helps.
SOURCE: How do i replace a
Remove the door panel, disconnect the window from the regulator. Push the window all the way up. Secure it either with duct tape, or prop good with screwdriver. Do not let it fall down. You should be able to work inside the door now to get the bolts and screws out to remove the motor and regulator.
SOURCE: how do I replace the
Glass & Regulator
On vehicles with power windows, disconnect the wiring couplings.
hope this helps
plz vote comment if need more help reply
For all types of power window problem and power windows not
working,i suggest you to go through the help links given below. Click the link
to go through its procedure to troubleshoot the problem :------
Power window problem
http://repairhelpcenter.blogspot.com/2012/01/pontiac-grand-am-power-window-not.html
------------
Power windows not working after car wash?http://howtobyme.blogspot.com/2011/11/power-windows-not-working-after-car.html
---------
power locks, power window and power mirror not working?
http://howtobyme.blogspot.com/2011/09/power-locks-power-window-and-power.html
------------
All power windows not working?
http://howtobyme.blogspot.com/2011/09/all-power-windows-not-working-on-2003.html
------------
How to remove window motor and regulator on Car?
http://howtobyme.blogspot.com/2011/09/how-to-remove-window-motor-and.html
-------------
Complete Diagnosis & Testing Power Windows?
http://repairhelpcenter.blogspot.in/2012/02/diagnosis-testing-power-windows.html
-----------This will help.Thanks.
On vehicles with power windows, disconnect the wiring couplings.
88 views
Usually answered in minutes!
×