Location changing instructions cabin filter 2003 pathfinder

autodr

• 260 Answers
• Posted on Oct 24, 2008

SOURCE: in cabin air filter

its most likely located behind the glove box. which usually comes unhinged fairly easily from its open position stoppers. then there would be an access panel to remove to get to filter(s)

SOURCE: pathfinder 2003 pcv

The PCV valve is located in the valve cover on the passenger side of the vehicle. The valve is closer to the firewall than it is to the front of the engine. It has a hose attached to it and threads into the valve cover.

Nissan Scope Technician- 10+ years experience is Nissan dealership

SOURCE: cabin filter 2001 xterra

Remove glove box and in cabin microfilter door will be right there. Note on some Xterras there is no filter installed and the box will need to be cut out in order to install kit. This is a fairly easy task that can be done in the vehicle. Just follow the directions and you should be ok.

SOURCE: how to change 2006 Nissan Pathfinder microcabin filter

To change the cabin air filters (there are two, that are in same location), you first have to remove the glovebox. The glovebox itself will not come off. You have to get a phillips head screwdriver to remove the 5 screws. With the glovebox closed, locate the two screws underneath and remove, one on each side. Next open the glovebox, remove the two screws at the top. The fifth screw is on the right behind the plastic molding. Pull back on the top of the lower piece of molding until the bracket pops out. The piece of plastic located just above that piece needs to be pulled out. No need to take it out all the way, just enough to get to the screw. Once removed, with the glovebox open take the fuse panel cover to the right off to allow you better grip. Pull both sides evenly until glove box pops out.
Get a flashlight and shine it on the right side behind where the glovebox was. There is a small plastic cover about 1 inch tall by 5 inches long. It is clipped in place. Push up on the plastic clip with your thumb while pulling out and down with your other finger/fingers. Behind this is one filter. Remove it best you can. Be careful, mine had dead bee's/wasps/dust/dirt/pinestraw/etc. After removing the first, you will notice a second one to the right of that. Slide that one to the left and remove the same way as the first. Look at those filters when you remove and take note the direction of AIR FLOW ^marking. Before replacing with the new ones, vacuum out inside where the filters go as best you can to remove all that crud that fell off of the old filters when removed.
Reinstallation is the reverse of how you removed. I hope this helps all my fellow Pathfinders out there.

SOURCE: I need to replace my Nissan Quest 2007 in cabin micro filter

I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.

Testimonial: "Finaly I found the air flow door with three screws and removed it. The filter will need replacement soon. It is been replaced one time at the dealer."