I have a Chrysler Sebring 1998 LXI. I had a short in the wires that power my auto-dim rear view mirror with compass. So I pulled the wires out of the snap-in plug that snakes up my windshielf and plugs into the bottom of the mirror, and I cleaned them. However, I failed to write down the order in which they need to be inserted back into the plug-in. I can't find anywhere that states what color wire goes into which slot. Would anyone know this? If you own this make/model, can you check what yours is?
Check the attached link: http://www.autozone.com/repairinfo/repairguide/repairGuideContent.jsp?pageId=0900c15280089a44
SOURCE: 2001 Chrysler Sebring Conv - lights on rear view mirror problem
also check to make sure your dimmer switch isn't turned all the way up. if the dimmer is all the way up your interior lights will stay on. check your dimmer switch
SOURCE: belt came off 1998 chrysler sebring lxi
you have two belts . put the large belt on first . it goes around crank pulley air conditioning pulley alternator pulley.loosen tension pulley to adjust belt. tension. then you put the other belt on power steering pump pulley and crank pulley. adjust belt tension loosen power steering pivot bolt. that it.
SOURCE: How Do i Remove Dash Board Speakers From A 1997 Chrysler Sebring
all u do is pop them out, they pull upu may need 2 use a screwdriver or something to get them started, then u follow the wire down and theres a lil connecter u can pull
SOURCE: electrochromic rear view mirror does not dim when turned on
These mirrors are all made by one company, no matter the car maker, they all have the same problems, they are very unreliable, if u have power to the mirror which I am 100% sure u do the mirror will need to be replaced, they are not repairable they are about $250-300
SOURCE: 2002 chrysler sebring lxi 2dr coupe wont start.
i have same car, same problem was $2 fuse located on top of battery (not beside drivers panel) Hopefully my problem is FIXED FOR GOOD!!!!
204 views
Usually answered in minutes!
×