How to change the vehicle speed sensor on 1997 toyota corolla
SOURCE: location for toyota rav4 vehicle speed sensor
Hi there:
The VSS (Vehicle Speed Sensor) is mounted on transaxle and contains a three pin electrical connector. Remove necessary components for access to VSS. Disconnect electrical connector at VSS...
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.
Thank you for using FixYa, have a nice day.
SOURCE: need to know where the vehicle speed sensor is
For the 1997 Toyota Camry 3.0L EFI
DOHC 6cyl the Vehicle Speed Sensor located
mounted on transmission.
Check this pic as reference...
Hope this help (remem,ber rated this post).
SOURCE: Remove the radio from 1997 Toyota Corolla
i have a 97 corolla as well, and i've changed the radio out several times on my own. if you take a small screwdriver and stick it in between the panel that goes around the around the area where the radio is, u should be able to pry it off relatively easy. just be sure to remove the sliders off the AC controls before you do. after you pop that panel off, you just have to disconnect the wiring harnesses going to the clock, hazard lights, rear defroster, and AC button. the radio is bolted in there with a mounting bracket, so you'll have to unscrew that as well. you'll need to unscrew that bracket from the radio you have in there, and mount it to the one you wanna install....hopefully this helps you out. it sounds harder than it really is.
SOURCE: My speedometer and odometer stopped working. Where
Her yo go and thanks for letting us know it was a DX model.
SOURCE: 99 toyota corolla hesitates while excellerating
Are you one of those people who TOP OFF the tank when filling up?
When the EVAP recovery system soak with few ounce of gasoline......the trap vapor will take few days escape.
EVAP system is design to handle fuel vapor. Few ounce of gasoline
can damage the fuel vapor recovery relay and decrease the service live
of the recovery lines.
=========
You can accelerate the process by locating the charcoal canister (near
the nose of the car and same side as your gas filler door)
MOVE the car to outdoor.
Disconnect the EVAP line and let it air out by itself.
DO NOT introduce any heat source or fan to speed up the process.
Reconnect this EVAP hose and use a small amount of starting fluid at the intake manifold.
Please post more information by Clicking on the comment link.
I will follow up.
5,865 views
Usually answered in minutes!
1 3
×