2004 impala gas filling problem

Hope this helps

If you made sure your battery connections are tight then you may need trace you hot wire for a bad connection around the fusible links that run from battery.

The nozzle may be going too far into the tank. Try holding the nozzle about half way into the tank fill tube.

If it's a 3.4l, it's at the back of the oil pan. The 3.8l is similar. Good luck!

have a 2008 chev Impala and the dual control puts out heat on one side and cold. Whats wrong with it, and How can I fix it

Get the heater core flushed if youy can verify that the valve in the upper heater hose moves when you go from hot to cold.

check the door switch.bobg22

For an 2004 CHEVROLET IMPALA - V6 3.8L 231ci GAS FI N K

Belt Routing Diagram Multiple Accesories


I dont know if this is your model engine, so, in DAYCO Catalog you can find other engine too.

I hope help you with this. Good luck ( remember rated this help).

check to make sure the top of your fuel tank is clear of mud or debris. Also check around your evap system which is right above the back axle of your pickup which is black plastic container. If you are dusty roads a lot this can become plugged off. There is a update at the dealerships for re-routing the vapor canisters on these pickups.

These engines did make a little rattle when first cranked. Are you running an ac/delco filter? i have seen a lot of engines make noise from cheap oil filters. they will let all the oil drain out so when you start it has to fill the filter back up before getting oil to engine