Replacing netural safty switch on steering colunn
SOURCE: crown victoria window motor replacement
remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the top half. one is right by the handle, which is the one i forgot the first time i took my door pannel off. carefully pull the panel upward, and outward at the same time. Once the panel is off, disconnect the controls, and remove the light from the panel. Remove the plastic cover very carefully, it will tear, just keeps noise, and air, and the elements out.
There will be 3 screws, they are torx bolts, once you pull those 3 out. They are located middle of the door towards the right side. The motor will drop down a little bit. disconnect the wires for the motor, and wiggle the motor off of the regulator. the crown vics have a decent size hole to get into the door panel, you can also remove the speaker if that would help you do it. other than that, it just lining up the new motor into the car, pushing it into the regulator, and putting the 3 bolts in, make sure they are snug, and not cross threaded. put everything back together, and your set.
SOURCE: i want to recharge the air conditioner on a 1992 crown vic
find your evaporator inlet outlet lines on the fire wall usually near heater core inlet outlet lines. then follow both lines until you find the one that goes to the compressor. that is your low side and the port should be on there
SOURCE: how to trouble shoot starting system 98 ford crown victoria
Also check to see if there is power in the start wire form the ignition switch, the wire is a white wire with pink stripe, most likely not a common problem, but still something that could go wrong. this wire will feed the starter relay under the hood...
SOURCE: Wipers will not park on 93 ford crown victoria
Hmmmm... if you replaced the motor you must have cleaned the area housing the arm mechanism. I had the same problem and found the problem to be in the arm assembly box on the firewall. Under the hood, triangular shaped box with snap on top was full of dirt, leaves and pine needles... I removed all the **** & my wipers now park as they should!!
235 views
Usually answered in minutes!
×